Owner's Manual

Table Of Contents

Control 24CT Micro:

9W 4W 2W 1W 0.5W Com 70V

N.C. 9W 4W 2W 1W Com 100V

Control 24CT MicroPlus:

N.C. N.C. 6W 12W 25W Com 70V

N.C. N.C. 12W 25W N.C. Com 100V

Control 24C Micro:

Hookup Chart

For Control 24CT Micro and the Control 24CT MicroPlus, connect the negative input to

the "Common" terminal and connect the positive input to the appropriate tap. The input

pins correspond to the taps of the transformer indicated on the label above each connec-

tor. For example, if the system is being driven from a 70V Distributed Line, and the 2W

tap is the desired connection, the positive input would be made to the input marked "2W,

Violet." The negative connection would be made to the "Common" pin.

On the Control 24C Micro, low impedance version, connect the negative wire to the "-"

terminal and connect the positive wire to the "+" terminal.

All other pins are "No Connection."

Paralleling Input Terminals - It is common to run two sets of wires - one set is the

input to the speaker and the other is the feed to the next speaker. In this case, simply par-

allel the two sets of wires to the same terminals on the speaker's terminal block.

Guide to the Pins for Connection - The locking input connector contains 7 terminals,

as marked above the connector. The pin functions are listed on the label located on the

terminal cover plate.

Step 4 - Add included metal strain relief as necessary. The Control 24C/CT Micro and the

24CT MicroPlus are equipped with two locations where the installer can affix strain relief con-

nectors - one is on the back of backcan and one is on the side (for applications with shallow

access). The location of these two attachment points is shown on the Product Feature

Identification on Page 3. The installer can attach a wide variety of installer provided fittings to

these points if the included equipment is not adequate for the particular installation. Refer to

Figure 6 shows the strain relief INCLUDED with the Control 24C/CT Micro and Control 24CT

MicroPlus.

Figure 6:

Included Metal Strain Relief