Owner's Manual

MTC-29UB
Instructions
U-Bracket
for
Control
29AV
Loudspeaker
The MTC-29UB bracket mounts the
Control
29AV
loudspeaker
to the walls,
decks and
ceilings
and provides
a degree
of
swiveling capability.
Read and
follow these instructions
carefully
before beginning.
Installing
speakers must be performed by experienced professionals.
If
you have any doubts about the
integrity
of
the structure you are mounting to
or
are not sure about the proper hardware
or
method to use,
consult
a
structural
engineer.
Q!y
1 pc.
2pcs
2pcs
2
pes
2pcs
Description
Bracket
Friction Gasket
Bolt,
6mm, 1mm
pitch, 16 mm
long,18-8SS
Fender
Flat
Washers for 6mm,
18-8SS
Spring Lockwasher for 6mm, 18-BSS
Step
1
-Test
Fit the Bracket to the
Speaker
Place
the bracket over the speaker cabinet. Gaps between the speaker surface and the bracket arms are to
be
filled
in with the
included friction gasket. Test the
included
hardware to make sure the
bolts,
washers
and
lock
washers fit
correctly.
Determine which
slot
you
will
be using and how the
bracket
will
be positioned
in
relation to the speaker. Determine which threaded
hole
in the speaker
will
be used (Note:
The
center
hole
is
closest
to the center
of
gravity, so the speaker
will
stay in position best when using the center
hole.)
Make sure you
will have enough wall clearance for your intended positioning. Remove the bracket from the
speaker.
Step
2
-
Install
the Bracket Securely
to Building Structure
Select the mounting area where the speaker
will be positioned. Be sure there is adequate
structural
material for mounting, such as a stud. Do not
rely
on
drywall,
acoustic
tiles,
etc. to support the weight
of
the
speaker.
Follow building
code requirements to
safely install
the bracket to the
building structure. Tighten
all
hardware permanently.
Step
3
- Install Speaker into Bracket.
Position the speaker
in
between the bracket arms and
install
the
included
hardware through the desired
slots
and into the speaker cabinet's threaded
holes.
Be sure to
place
the friction gaskets between the
speaker and the bracket arms then tighten the
bolts loosely,
not tight.
Step
4
- Aim the Speaker
Rotate the speaker
until it is aimed in the desired direction, then secure the side
bolts permanently
with a
wrench.
Step
5-
Recommendation: Safety
Cable
It
is strongly
recommended that the speaker be secured to the mounting structure with a
properly
rated
safety
cable.
JBL
Professi
on
al, 8500
Balboa Blvd ,
Northridge, CA 91329 (Rev-
01
-11115/11)