JBLP2744-WEM1-OM.
JBLP2744-WEM1-OM.qxd 10/29/08 2:42 PM Page 2 IMPORTANT SAFETY INSTRUCTIONS 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. 8. Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat. 9.
JBLP2744-WEM1-OM.qxd 10/29/08 2:42 PM Page 3 THANK YOU FOR CHOOSING A JBL® PRODUCT For more than 60 years, JBL, Inc., has been involved in every aspect of music and film recording and reproduction, from live performances to the recordings you play in your home, car or office. You can be confident that the JBL® system you have chosen will provide every note of enjoyment that you expected – and that when you think about purchasing additional audio equipment, you will once again choose a JBL product.
JBLP2744-WEM1-OM.qxd 10/29/08 2:42 PM Page 4 CONNECTIONS NOTES: For the sake of simplicity, throughout this manual the term “source” is used when describing connections and operation. This would apply to any device such as an A/V receiver, audio component, computer or portable music player. Right Speaker Left Speaker The JBL On Air WEM-1 may be connected to your source in several ways. First, determine how you would like to use the WEM-1; then follow the setup instructions for that application.
JBLP2744-WEM1-OM.qxd 10/29/08 2:42 PM Page 5 Step 3. Connect the speaker wire to the push terminals on the receiver module A and the terminals on the rear of your speakers, as shown in Figure 4. Please note that the speaker wire features a polarity indicator to help distinguish its two conductors. Use this polarity indicator to ensure that you are connecting the positive (+) terminal on one speaker to the positive (+) terminal on the other, and the negative (–) to the negative (–).
JBLP2744-WEM1-OM.qxd 10/29/08 2:42 PM Page 6 Auto On/Standby The JBL On Air WEM-1 will automatically enter the Standby mode after approximately 10 minutes, when no signal is detected from your system. The WEM-1 will then power on instantly when a signal is detected. When Mute 0 is engaged, auto turn-off is deactivated.
JBLP2744-WEM1-OM.qxd 10/29/08 2:42 PM Page 7 Vertically Stand-Mounting the Receiver Module Step 1. Remove the corner screws located on the left side of the receiver module when viewed from the bottom, looking at the front, as shown in Figure 8. MAINTENANCE AND SERVICE All wiring connections should be inspected and cleaned or remade periodically. The frequency of maintenance depends on the metals involved in the connections, atmospheric conditions and other factors, but once per year is the minimum.
JBLP2744-WEM1-OM.qxd 10/29/08 2:42 PM Page 8 JBL and Control are trademarks of Harman International Industries, Incorporated, registered in the United States and/or other countries. JBL Control NOW is a trademark of Harman International Industries, Incorporated. Harman Consumer Group, Inc., 250 Crossways Park Drive, Woodbury, NY 11797 USA 8500 Balboa Boulevard, Northridge, CA 91329 USA 516.255.4JBL (4525) (USA only) www.jbl.com © 2008 Harman International Industries, Incorporated. All rights reserved.