Stage 2 Architectural Loudspeakers Installation Guide 1.
Overview Associated Accessories The following products are supported within this document. There are several accessories available for new construction installations as well as square grille kits to change the appearance of the in-ceiling speakers. In-Wall Models Preconstruction Brackets Supported Products Stage 250WL 2-way Dual 5.25" In-Wall WB81 Pre-Construction Bracket for 8" In-Wall Stage 260W 2-way 6.
Safety Warnings IMPORTANT! HARMAN International assumes no responsibility for improper installation of hardware or for any personal injuries or product damages resulting from improper installation or a fallen loudspeaker. Read through this document in its entirety and heed all warning before proceeding with the installation of these product(s). IMPORTANT! Installation Precautions Due to the nature of this product, there are several precautions to follow before installation can begin. 1.
Installation Before proceeding with the installation be sure and read through these instructions carefully and in full to ensure that the installation will be complete and accurate. Should at any time these instructions seem unclear, contact your dealer or customer support for assistance.
Installing the Speakers 1. Follow the steps under Preinstallation Preparations that apply to the installation. 2. Set the XL-2 legs on the speaker to the installation position. Must be inside the frame of the speaker in order to install speaker into cutout. XL-2 Leg inside frame of speaker 3. Attach the included safety wire to a stud inside the wall/ ceiling near the side of the speaker with the safety ring eyelet. 4. Pull wire through pre-construction bracket or hole in wall/ ceiling. 5. Strip ¼" (6.
Specifications In-Walls Stage 250WL 1" (25mm) Aluminum dome High Frequency Transducer with High-Definition Imaging (HDI™) horn Stage 260W Stage 280W 1" (25mm) Aluminum dome with High-Definition Imaging (HDI™) horn 1" (25mm) Aluminum dome with High-Definition Imaging (HDI™) horn Low Frequency Transducer Dual 5.25" (130mm) Polycellulose cone woofer 6.
In-Ceiling (Standard) Stage 260C Stage 280C High Frequency Transducer 1" (25mm) Aluminum dome with Acoustic Lens Low Frequency Transducer 6.5" (165mm) Polycellulose cone woofer 8" (200mm) Polycellulose cone woofer Recommended Amplifier Power 20-100W RMS 20-120W RMS Frequency Response 50Hz-25kHz (-6dB on-axis) 42Hz-25kHz (-6dB on-axis) Sensitivity (2.
In-Ceiling (Special Use) Stage 260CDT Stage 260CSA Stage 280CSA High Frequency Transducer Dual 3/4" (20mm) Aluminum dome with Acoustic Lens 1" (25mm) Aluminum dome with Acoustic Lens 1" (25mm) Aluminum dome with Acoustic Lens Low Frequency Transducer Dual VC 6.5" (165mm) Polycellulose cone woofer 6.
Installation Tools Pre-Construction Brackets JBLWB52 JBLWB61 (New) JBLWB81 (New) JBLCB6SA JBLCB8SA Description Rough-In Bracket for 5" In-Wall Rough-In Bracket for 6" In-Wall Rough-In Bracket for 8" In-Wall Rough-In Bracket for Angled 6" InCeiling Rough-In Bracket for Angled 8" InCeiling Products Supported 250WL 260W 280W 260CSA 280CSA Square Grille Kits JBLSGK6 JBLSGK8 Description Square White Paintable Grille for 6" In-Ceiling Square White Paintable Grille for 8" In-Ceiling Products
Harman International Industries, Incorporated. 8500 Balboa Blvd, Northridge CA 91329 United States. European Representative: Harman International Industries, Incorporated. EMEA Liaison Office, Danzigerkade 16G, 1013 AP Amsterdam, The Netherlands. UK Business Address: Ground Floor, Westside 2, London Road, Apsley, Hemel Hempstead, Hertfordshire, HP3 9TD, United Kingdom. © 2022 Harman International Industries, Incorporated. All Rights Reserved.