Specifications
English
7
www.jbl.com
Some speakers may contain up to three independent switches for high-frequency, low frequency and mid-range frequency.
Depending on the frequencies in the audio being played one or more limit switch may be triggered while the remaining
frequency ranges may continue to output normally. In any case, pause the audio or reduce the volume level until the limit
switches have returned to their operational state.
WARNING
HARMAN International assumes no responsibility for improper installation of hardware or for any personal
injuries or product damages resulting from improper installation or a fallen loudspeaker.
LIMITED WARRANTY
JBL Conceal Invisible Loudspeakers are warranted against defects. The duration of the speaker’s warranty depends on the
laws in the country in which it was purchased. Your local JBL retailer can help you determine the length of your warranty.
SPECIFICATIONS
Specications C62 C83 C86 C82W
Type: 2-way 3-way 2-Panel 3-way
2-Panel Subwoofer
system
LF Driver: 6.5-inch (165mm) woofer 8-inch (203mm) woofer 8-inch (203mm) woofer
8-inch (203mm) woofers
(2 per panel)
MF Driver: N/A
1.18-inch (30mm)
transducer
Four 1.18-inch (30mm)
transducers
N/A
HF Driver:
1.18-inch (30mm)
transducer
1-inch (25mm)
transducer
1-inch (25mm)
transducer
N/A
Input Power: 50 - 100 WRMS 50 - 160 WRMS 50 - 200 WRMS
60 - 100 WRMS (per
panel)
Impedance: 4 Ohm 4 Ohm 4 Ohm
Selectable 4 Ohm or 16
Ohm (each panel)
Sensitivity:
83 dB/1W/1m measured
in-room
84 dB/1W/1m measured
in-room
84 dB/1W/1m measured
in-room
86 dB/1W/1m measured
in-room
Frequency Response:
45 Hz - 20 kHz (-6 dB)
measured in-room
45 Hz - 20 kHz (-6 dB)
measured in-room
45 Hz - 20 kHz (-6 dB)
measured in-room
30 Hz - 300 Hz (-6 dB)
measured in-room
Crossover Frequency: 600 Hz 500 Hz 600 Hz; 10 kHz
N/A (requires amplier
with HPF and LPF)
Enclosure Type:
Sealed, with wooden
back-box
Sealed, with wooden
back-box
Sealed, with wooden
back-box
Sealed, with wooden
back-box
Panel Dimensions:
11-7/8" H x 15-7/8" W x
3-7/8" D
(302mm H x 403mm W x
98mm D)
22" H x 15-7/8" W x
3-7/8" D
(559mm H x 403mm W
x 98mm D)
MF/HF Panel: 11-7/8" H
x 15 -7/8" W x 3-7/8" D
(302mm H x 403mm W
x 98mm D)
LF Panel: 22" H x 15-
7/8" W x 3-7/8" D
(559mm H x 403mm W x
98mm D)
30" H x 15-7/8" W x
3-7/8" D
(762mm H x 403mm W x
98mm D)
Cut-out Dimensions:
12" H x 16" W
(305mm H x 406 W)
22-1/8" H x 16" W
(562mm H x 406mm W)
MF/HF Panel: 12" H x
16" W
(305mm H x 406mm W)
LF Panel: 22-1/8" H x
16" W
(562mm H x 406mm W)
30-1/8" H x 16" W
(765mm H x 406mm W)
Mounting Depth: 3-3/8-inches (86mm) 3-3/8-inches (86mm) 3-3/8-inches (86mm) 3-3/8-inches (86mm)
Pre-construction Board
(PCB):
C12PCB C22PCB
MF/HF Panel: C12PCB
LF Panel: C22PCB
C30PCB
Protection:
Two independent self-
resetting devices (LF and
HF)
Two independent self-
resetting devices (LF and
MF/HF)
Three independent self-
resetting devices (LF, MF
and HF)
N/A (requires amplier
with limiter)