CBT 200LA-1 Assembly & Bracket Installation Guide INCLUDED: Top Speaker Module Bottom Speaker Module Speaker Bracket Coupler Plate M6-34L M6-12L M6-Nuts SS Lockwashers Swivel-Tilt Wall Bracket SS Flatwashers M6-20L Flat head [Not shown to relative scale] Switch covers
CBT 200LA-1 Assembly & Bracket Installation Guide – Page 2 WALL SURFACE MOUNTING Note that the BRACKET ASSEMBLY consists of a SPEAKER BRACKET and a WALL BRACKET. 1) RUN WIRING -- Run the wiring from the power amplifier to the location desired for mounting the JBL CBT Loudspeakers. 2) ATTACH WALL BRACKET TO WALL -- Using a level to ensure that the WALL BRACKET is straight, secure the WALL BRACKET to the wall. Be sure to use the appropriate wall anchors for attaching the bracket.
CBT 200LA-1 Assembly & Bracket Installation Guide – Page 3 3) ORIENTING TOP & BOTTOM SPEAKER MODULES This drawing shows the proper orientation of the two speaker modules, where the coupler plate attaches and where the wall bracket attaches (onto the coupler plate). IMPORTANT: Note that the speaker will not work correctly if the TOP AND BOTTOM SPEAKER MODULES are not oriented exactly as shown.
CBT 200LA-1 Assembly & Bracket Installation Guide – Page 4 4) CONNECT SPEAKER MODULES TOGETHER VIA COUPLER PLATE Attach COUPLER PLATE to the TOP AND BOTTOM SPEAKER MODULES, as shown, with 8 pcs of M6-20L flathead bolts, through to TOP AND BOTTOM SPEAKER MODULE’S rear cabinet insert points.
CBT 200LA-1 Assembly & Bracket Installation Guide – Page 5 6) SLIDE SPEAKER WITH SPEAKER BRACKET ONTO WALL BRACKET n Once the wall mount has been attached to the wall and speaker mount has been attached to the speaker, loosely install the M6-L34 PIVOT BOLT (bolt, lock washer and flat washer on one side and flat washer, lock washer & nut on the other side) of the WALL BRACKET.
CBT 200LA-1 Assembly & Bracket Installation Guide – Page 6 o Insert the top tilt-angle bolt through the appropriate hole – one of the preset angle holes or the slot for continuous adjustment capability (see below for more information about tile angles). Install with M6-L34 bolt, lock washer and flat washer on one side and flat washer, lock washer & nut on the other side, as shown in Drawing o . Make sure bolt goes through holes in WALL BRACKET and in SPEAKER BRACKET.
CBT 200LA-1 Assembly & Bracket Installation Guide – Page 7 11) USING OPTIONAL MTC-CBT-FM1 FLUSH-MOUNT WALL BRACKETS – The optional MTCCBT-FM1 brackets allow installing the speaker with its back very close to the wall. It is recommended to use two brackets – one on the top and one on the bottom – for stability.
CBT 200LA-1 Assembly & Bracket Installation Guide – Page 8 CBT 200LA-1 Bracket Dimensions JBL Professional 8500 Balboa Blvd.
