Operation Manual

JBL CLUB
• The Club-5501 features two positive (+) and two negative (-) terminals. To power two subwoofers in parallel, connect one sub’s positive (+)
and negative (-) leads to the positive and negative terminals on the left, and the other sub’s positive and negative leads to the positive and
negative terminals on the right. To power two subwoofers in series, connect one sub’s positive (+) lead to the positive terminal on the left, and
the other sub’s negative (-) lead to the negative terminal on the right, then connect left sub’s negative lead to the right sub’s positive lead.
NOTE: Minimum speaker impedance for stereo full-range and subwoofer operation is 2ohms. Minimum speaker impedance for bridged operation is 4ohms.
4. Fuses:
• Replace only with fuses of the same amperage:
°
Club-704, Club-5501: 30A
°
Club-4505: 30A
5. Power Input Connectors:
• Power: Run power wire from the +12V input to the positive terminal of the vehicle’s battery. Install an appropriate fuse holder and fuse (60A minimum
on Club-704 and Club-5501, 105A minimum on Club-4505) within 18” (457mm) of the battery. Make sure the wire is not damaged or pinched during
installation. Install protective grommets when routing wires through the bulkhead or other sheet metal. Use larger-gauge wiring for longer runs.
°
Club-704 minimum wire size: 10 gauge
°
Club-4505, Club-5501 minimum wire size: 8 gauge
6
If you’re connecting only one sub, you can use either set of positive and negative terminals.
4-ohm subwoofer
2-ohm subwoofer 2-ohm subwoofer
PARALLEL WIRING
SERIES WIRING
4-ohm subwoofer