User manual

2. Attach the mounting bracket to the wall. Be sure to use

appropriate anchors.

3. Connect the stripped bare wires to the input terminals of the

JBL Control CRV speakers.

4. Set the tap selector switches to the desired 70V/100V tap.

THRU position is not advised due to parallel speakers providing

too low of an impedance for most low impedance power

ampliﬁ ers.

5. The mounting brackets are designed to trap the ﬂ ange of the

JBL Control CRV speaker by securing the mounting-bracket

cap with two screws through the bottom of the mounting

bracket. Run the wire through the rear cable-management

hole in the mounting bracket, and rest the JBL Control CRV

speaker’s rear ﬂ ange in the mounting bracket, as shown. This

will support the weight of the speaker. Now slide the mounting

bracket caps over the assembly. Secure the mounting-bracket

cap by inserting two #10-32 x 2” (M5 51 mm) screws (provided)

through it and into the bottom piece of the mounting bracket

and tightening.

3/4-ROUND EXTERNAL

CORNER WALL MOUNTING

(Horizontal or Vertical Orientation)

1. Secure three corner/wall-mounting brackets together by

using two #10-32 x 1/2” screws provided, as shown. Attach the

mounting bracket to the wall.

Appropriate

anchors

Mounting-Bracket

Covers

Mounting-Bracket

Covers

Speaker 1

Speaker 2

Speaker 3

#10-32 x 1/2" Screws (2)

INSTALLATION

CAUTION: Installation must be

done by qualiﬁ ed persons using

safe rigging standards

The installer is responsible for proper selection

and use of mounting hardware, to properly and

safely wall-mount the speakers