CS300.1 CS60.4 CS60.2 CAR AUDIO POWER AMPLIFIER OWNER’S MANUAL www.jbl.com The Official Brand of Live Music.
INSTALLATION THANK YOU for purchasing a JBL CS Series amplifier. In order that we may better serve you should you require warranty service for your new amplifier, please retain your original purchase receipt and register your new JBL amplifier online at www.jbl.com. WARNING Playing loud music in an automobile can hinder your ability to hear traffic and permanently damage your hearing. We recommend listening at low or moderate levels while driving your car.
INSTALLATION POWER CONNECTIONS The CS amplifiers require a reliable connection to the vehicle’s electrical system in order to perform optimally. See Figures 1, 2 and 3 for terminal connection locations. Please adhere to the following instructions carefully: Ground Connection Connect the amplifier’s Ground (GND) terminal to a solid point on the vehicle’s metal chassis, as close to the amplifier as possible. Refer to the wire gauge chart to determine minimum wire gauge size.
APPLICATIONS – CS300.1 The CS subwoofer amplifier is a single-channel amplifier. There are two sets of terminals to make it easy to connect multiple woofers. Either set of (+/–) terminals may be used when connecting woofers. Figure 4. CS subwoofer amplifier with two woofers connected. To the right are two application diagrams to help plan your subwoofer system installation. Figures 4 and 5 show how to configure the CS300.1 subwoofer amplifier.
APPLICATIONS – CS60.4 The CS60.4 can be set up for stereo 4-channel, 3-channel or bridged 2-channel operation, as shown in Figures 6 through 8. Front Left Front Right Figure 6. CS60.4 amplifier in 4-channel (stereo) operation to drive front and rear full-range speakers. NOTE: For simplicity, Figures 6 through 8 do not show power, remote and input connections. Rear Left Rear Right Front Left Front Right NOTE: Minimum speaker impedance for stereo operation is 2 ohms.
APPLICATIONS – CS60.2 Figure 9. CS60.2 used in 2-channel (stereo) Left Right operation to drive a set of full-range speakers. Left Right Figure 10. CS60.2 used in bridge mode to drive a subwoofer.
CONTROLS AND SETUP TROUBLESHOOTING SETTING THE CROSSOVER(S) Determine your system plans and set the crossover mode switch accordingly. If your system design does not include a subwoofer with the CS60.4, set the crossover mode to FLAT and skip to “Setting Input Sensitivity.” SYMPTOM No audio (POWER LEDs are off) Initially set the crossover frequency control midway.
SPECIFICATIONS CS300.1 • 200W RMS x 1 channel at 4 ohms and ≤1% THD + N • Signal-to-noise ratio: 100dBA (reference 1W into 4 ohms) • 300W RMS x 1 channel at 2 ohms, 14.4V supply and ≤1% THD + N • Dynamic power: 460W at 2 ohms • Effective damping factor: 6.395 at 4 ohms • Frequency response: 10Hz – 300Hz (–3dB) • Maximum input signal: 6V • Maximum sensitivity: 100mV • Output regulation: – 0.07dB at 4 ohms • Dimensions (L x W x H): 12-11/16" x 10-1/4" x 2-3/16" • Fuses: 20A x 2 CS60.