CS Commercial Solution Series CSR SERIES • CSR-V • CSR-2SV • CSR-3SV Remote Control User Guide CSR-V CSR-2SV CSR-3SV
DECLARATION OF CONFORMITY Manufacturer’s Name: Manufacturer’s Address: Harman Signal Processing 8760 S.
Remote Control Overview The JBL Commercial® CSR series remote controls, including CSR-V, CSR-2SV, and CSR-3SV, can use analog DC voltage to provide logic control ranging from source selection and volume. Wired with Cat 5 cable with universally accepted RJ-45 connectors up to 1000 feet (305 m) length, the CSR series remote controls allow you to remotely select the source and/or control the volume on the CSM mixer.
Remote Control Dimensions Install the remote control on the wall according to the needs of your audio system, see figures A, B, C, and D. Figure A: CSR-V Dimensions (EU Version) 86mm 18.8mm 60mm 86mm Figure B: CSR-2SV/CSR-3SV Dimensions (EU Version) 86mm 2.750 18.8mm 60mm .723 86mm 4.500 3.280 Figure C: CSR-V Dimensions (US Version) .723 2.750 3.280 4.500 Figure D: CSR-2SV/CSR-3SV Dimensions (US Version) 2.750 4.500 2 .723 3.280 2.750 .
Wiring the Remote Control The CSR series remote controls can be wired with the CSM-21 or CSM-32 mixer, see figure E and figure F. Figure E: Connecting to CSM-21 Mixer CSR-2SV and CSM-21 CSR-V and CSM-21 Figure F: Connecting to CSM-32 mixer CSR-2SV/CSR-3SV and CSM-32 CSR-V and CSM-32 Warning: The installation of the CSR remote controls MUST be accomplished with the use of cable which is rated VW-1 or higher.
Using the Remote Control Source Selection The Source Selection control on the remote control only functions when the Source Selector knob for that zone is set to “REMOTE” on the mixer. When the remote control is active, the green LED on the remote control below the Source switch (labelled ACTIVE) lights. When this LED is not lit, the remote source control is not operational. Volume Control The LEVEL on the mixer is ALWAYS operational, regardless whether the Source Selector is active or not.
Specifications Connector: RJ-45 Cable type: Category 5, straight-through cable, T568B standard Maximum Cable Length: 1000 ft. (305 m) Shipping Weight: .55lbs. (250g) Trouble-shooting Problem 1: The green LED on the remote control below the Source switch (labelled ACTIVE) can not be lit. Solution: In normal cases, the P11 jumper on the PCB can not be accessed by the user for any operation, yet is removable for disabling the LED. If the LED is not lit, you may check the P11 jumper is installed properly.
JBL Commercial 8760 South Sandy Parkway Sandy, UT 84070 USA (801) 566-8800 Printed in China Part Number: 18-1221-A Issue: 06/11