JBL OnBeat™ speaker dock for iPod/iPhone/iPad Owner’s Manual
Important Safety Instructions Regulations FCC Statement and Warning Please read thefollowing precautions before use: 1. Read these instructions. 12. Use only with the cart, stand, tripod, bracket or table specified by the manufacturer or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 13.
English connecting and setting up your jbl OnBeat™ SPEAKER DOCK 1. C arefully unpack your speaker dock, and confirm that all the items shown here are included: JBL® OnBeat speaker dock, power supply, AC cord*, remote control, iPod®/iPhone® adapter clip and iPad™ adapter clip. 3. I f you are going to use your JBL OnBeat speaker dock with another audio source, plug one end of a 3.
DC IN POWER AUDIO IN USB 6. Y our JBL OnBeat speaker dock includes two adapter clips: one for an iPod touch®/iPod classic®/iPhone device, and another for an iPad device (NOTE: the iPod 5G and iPod nano® models do not require an adapter clip.) The adapters allow you to dock units with or without third-party skins attached. Attach the appropriate adapter clip to the JBL OnBeat speaker dockdock as shown below.
English Using your jbl OnBeat SPEAKER DOCK To turn the JBL OnBeat speaker dock on, press the Power button on the unit. The unit’s status LED will glow white when the system is on. To turn the JBL OnBeat speaker dock off, press the Power button on the unit again. The status LED will turn off. remote control functions To place the JBL OnBeat speaker dock into the Standby mode while an iPod, iPhone or iPad device is docked, hold down the Play/Pause button on the remote for two seconds.
rotating the dock When an iPod or iPhone device is docked in the JBL OnBeat speaker dock, you can rotate the dock to the landscape mode. IMPORTANT: You cannot rotate the dock when an iPad device is docked. Synchronizing with YOUR iTunes LIBRARY To rotate the dock to the landscape mode, turn it 90 degrees counterclockwise. To rotate it back to the portrait mode, turn it 90 degrees clockwise. The dock will hold in place at the portrait and the landscape positions.
English Troubleshooting Your JBL OnBeat SPEAKER DOCK Problem Solution No sound (amber LED is not illuminated): •M ake sure that the power supply is properly connected to the JBL OnBeat speaker dock and to a working AC outlet. No sound (white LED is illuminated): • Touch the Volume Up (+) button to increase the system volume. • I f you’re using a docked iPod/iPhone/iPad device, make sure that it is properly docked in the JBL OnBeat speaker dock.
Specifications Compatibility*: iPad Wi-Fi® + 3G, iPad Wi-Fi, iPhone 4, iPhone 3GS, iPhone 3G, iPhone, iPod touch 4G, iPod touch 3G, iPod touch 2G, iPod touch, iPod nano 5G, iPod nano 4G, iPod nano 3G, iPod nano 2G, iPod nano, iPod 5G, iPod classic Transducers: 2 x JBL® Phoenix SE full-range transducers Power: 6.
English HARMAN Consumer, Inc. 8500 Balboa Boulevard, Northridge, CA 91329 USA © 2011 HARMAN International Industries, Incorporated. All rights reserved. JBL is a trademark of HARMAN International Industries, Incorporated, registered in the United States and/or other countries. JBL OnBeat is a trademark of HARMAN International Industries, Incorporated. iPhone, iPod, iPod classic, iPod nano, iTunes and iPod touch are trademarks of Apple Inc., registered in the U.S. and other countries.
