Owner's Manual

7
EN
USING BANANA CONNECTORS:
BASIC SINGLE-WIRE CONNECTION
To connect the speakers using a single wire, connect the amplifier to each speaker as shown in the illustration
below.
IMPORTANT: Do not remove the metal jumper bars from between the two sets of connectors
when connecting the speaker wires.
BI-WIRE CONNECTION
All Stage series speaker connector panels have two sets of input connectors that are joined by metal jumper bars.
The upper set of connectors is for the tweeter driver assembly, and the lower set of connectors is for the woofer(s).
This arrangement allows you to bi-wire the speakers using a single stereo amplifier or using two stereo amplifiers.
Bi-wiring can offer performance advantages and more flexibility in power-amplifier selection over a conventional
single-wire connection.
Before bi-wiring the speakers, remove the jumper bars.
1. 2. 3. 4.
+–
Receiver or Amplifier
(One Channel Shown)
Speaker
Connector Panel
Do Not Remove
Jumper Bars
Remove Jumper Bars
Tweeter Connector
Woofer Connector