Owner's Manual

BASIC SINGLE-WIRE CONNECTION
To connect the speakers using a single wire, connect the amplifier to each speaker as shown in the illustration below.
You can use either set of connectors on the connector panel.
IMPORTANT: Do not remove the metal jumper bars from between the two sets of connectors when
connecting the speaker wires.
Receiver or Amplifier
(One Channel Shown)
+
~-~
Bl-WIRE CONNECTION
Speaker
Connector Panel
Use Either Set
~ of Connectors
~~ ~~~~~ ~N~~~~
Jumper Bars
HDI series loudspeakers connector panels that have two sets of input connectors are joined by metal jumper bars.
The upper set of connectors is for the compression-driver/horn assembly, and the lower set of connectors is for
the woofer(s). This arrangement allows you to bi-wire the speakers using a single stereo amplifier or using two
stereo amplifiers. Bi-wiring can offer performance advantages and more flexibility in power-amplifier selection over a
conventional single-wire connection.
Before bi-wiring the speakers, remove the jumper bars.
Remove Jumper Bars
@ @ @ @
ill
•
•
~
c{},
Compression Driver/
~
: ~ ~ ri Hom Connectors
___ J,
Woofer
: ~ ~ 1iYi Connectors
-.=- °? d
@ @ @ @
6