Owner's Manual
Wire Configuration
6P
REMOTE
CONTROL
(ANT
JACK)
[==][Illlill-_j
PINK
( REAR CAMERA
DET
)--------__,
(ILL)
__
O_RA_NG_E
____
~
12P
CONNECTOR
(REM)
------==---_B_L_U_E___.
(ACC)
RED
(GROUND)------B_LA_C_K____.
WHITE
GRAY
(
FRONT
LEFT
)
WHITE/BLACK
GRAY/BLACK
GREEN
VIOLET
(
REAR
LEFT)
GREEN/BLACK
VIOLET/BLACK
NOTE:
RED
(FRONT LINE OUT)
WHITE
RED
(REAR LINE OUT)
WHITE
RED
(AUX)
WHITE
(REAR CAMERA)
(USB)
RED
(SUBWOOFER)
WHITE
(FRONT
RIGHT)
(
REAR
RIGHT)
1.
When wiring, the red lead
is
recommended
to
be wired
to
ACC/ignition power lead.
2.
Make sure that the black wire on the wiring harness
is
connected
to
a good ground point
on the boat.
If
the chassis
of
the boat
is
used
as
a ground point, make sure that the surface
is
scraped clean
of
paint before attaching the wire
to
it.
It
is
recommended
to
connect the
black ground wire directly to negative terminal (-)
of
the boat battery.
3.
Before wiring your system, disconnect your boat battery's positive(+) cable. This helps
prevent damage
in
case
of
a short.
4