II JBL Arena 26Be Component System HARMAN T • Owner's Manual Iii■ Mode d'emploi Manual del propietario Hi·Res llml ~ • fflP~M ..
Congratulations! You have just purchased ARENA 26Be 75 years in the making! "You only live once!" Live it with Great JBL Sound Thank you for choosing a JBL Arena 26Be component system. To get the best performance from your new speakers, it is strongly recommended that you have a qualified professional install them. Although this manual provides general instructions about installing the speakers, it does not include exact installation methods for any particular vehicle.
II. JBL Arena 26Be Component System ..HARMAN WHAT'S IN THE BOX 2X 8X • Thread the tweeter wire through the center of the mounting cup. • Insert the tweeter into the cup, then twist clockwise to lock it in place. • Thread the pressure-fit nut onto the back of the flush-mount cup. Twist clockwise to hand-tighten. 2X Surface-mounting the tweeters Surface-mounting is ideal for installing the tweeters on a sail panel, dash corner, or door panel.
fklshmount r+ L Surface mount - J ~.~ L - Stealth mooot r9~ L Rear mount J - •► J L9: Installing the 6.5" woofers The woofers are usually mounted in your vehicle's factory woofer locations, which are typically in the doors (front) or side panels (rear). If you choose to mount them 1n a custom location, mounting them higher will raise the soundstage, while mounting them lower ,n the doors will provide excellent bass response.
NOTES: Non-bi-amping • Use appropriately sized speaker wire; 14- or 16-gauge is recommended. • Make sure your amplifier's RMS power rating is suitable for the tweeters and woofers (see specifications). • You will need to use a total of four channels of amplification from two 2-channel amplifiers or one 4-channel amplifier. IMPORTANT: Because of the lower impedance of the drivers, do not wire In parallel or bridge amplifier channels to prevent overheating the amplifier.
Dimensions Tweeter Surface-Mount Cup Dimensions Woofer Physical Dimensions Frame Outer Diameter (A) 6-15/16 in / 176 mm Grille Tray Outer Diameter (B) 6-15/16 in / 176 mm Magnet Outer Diameter (C) 3-1/4 in/ 82.2 mm Frontal Grille Protrusion (D) 29/32 in/ 22.8 mm Mounting Hole Diameter (E) 5-5/16 in/ 135 mm Mounting Depth (F) 2-13/16 in/ 72 mm Fixture Outer Diameter (A) 1-3/4 in / 44.3 mm Fixture Mounting Hole Diameter (B) 1-3/4 in/ 44.3 mm Fixture Mounting Depth (C) 1-7/16 in / 36.
Specifications Arena 26Be 1• Tweeter Arena 26Be 6.5" woofer Dome/Cone material Beryllium dome Coated Carbon Fiber Waveguide/ Grille Aluminum Die-casting SPCC Basket material Aluminum Die-casting Aluminum Die-casting Power Handling 50Wrms 100Wrms Frequency Response 1KHz-40kHz 60Hz-6kHz Sensitivity (2.83V/1m) 95dB 91dB Impedance 4ohm 4 ohm Fs 1.
~ HARMAN J ~ F&:!~%: - - - - -- - - - -- ffi~ (~~,mht) BM:20 $ ,Ej E3 ~~%W: - fflp~;g: - - - - - (ffi~~EP~) ~~~12;: _ itg!11: (l!l~tlie) : _ _ "= ~~m~: ffitl!lOO* fil" ~ii:, J'm~~%~±Ji~*?ciiE#~~~£~~f1!:li5lat l±l~1:foJ:J~ffi*~J§ij&~otl 7 ~t?1Z~t)(iiil, ffl1Z ~~F&:iat~lll3)!~~~£m~#mfH#Ji!'.lH'f*?ciiE~~~JM5 ¥J;, iltt1t ~iMH~ ,l~!.~EP~o *?ciiEP-1@~i!'.li&:i~!to/J~ff-ifFfr.f~~ ~i&~¥-J:fmf~~F □ ij&~, ffi~~,;Zt~~ffo ffl1Z~x1F&:i~/l,!H.lii%, ~%~~, ~i&~tHhtiJ~F*~5.l~t)(!H#Ji!'.
CA_JBL__Arena 26Be components_OM_EN+FR+ES+CN_SOP_V6
