Owners Manual
7
Power Connection
Power to the M-Patch 2 is required only if you wish to use the
headphone amplier, or view the illuminated led indicator lamps.
The included power supply can be connected from mains power to the
power connector socket located on the rear panel of the M-Patch 2.
The Blue led on the front panel (next to the mono/stereo control switch) will
illuminate when the external power supply is connected and mains power is
present.
* Note: All passive attenuation functions operate fully without the connection of
the power supply. This enables portable use of the M-Patch 2 without restriction.
FRONT PANEL CONTROLS
Stereo/Aux Input Selection Control
The input selection controls on the front panel of the
M-Patch 2 allow selection of either Stereo or Aux input
source material to be routed to the output pairs for
immediate listening and attenuation control.
Select the “stereo” position to activate the main stereo input source connected
to the Combination XLR/1/4-inch (6.5mm) TRS inputs, or select “Aux” position
to activate the RCA and 1/8-inch (3.5mm) stereo mini-jack input source.
NOTE: Do not connect signal sources to the RCA and 3.5 mm stereo mini jack
simultaneously.
1&2 Output Selector Switch
The 1/2 output switch on the front panel determines the
balanced XLR output pair, either 1 or 2, that will be used
to monitor the input signal currently selected using the
STEREO/AUX switch.
Press the desired switch to toggle between output destinations.
* Note: If you have more than one pair of monitor speakers you could create a
perfect switching facility for toggling between near-field and lager format active
room monitors.