Guia de instalaci6n del altavoz marino JBL Tower X -- JBL Tower X Marine fiitiH~~fiffi ID JBL Tower X Marine Speaker Installation Guide Guide d'installation de l'enceinte marine JBL Tower X ml
El JBL TOWER X MARINE SPEAKER HARMAN THANK YOU FOR YOUR PURCHASE ... Your JBL product has been designed to provide you with the performance and ease of operation you would expect from JBL. ABOUT THE MANUAL This manual describes general installation guidelines. However, please note that proper installation of marine audio components requires qualified experience.
DIMENSIONS 6.5" 8" • Mounting the speaker 1. Place the clamp around the horizontal bar of the tower. 2. Use the included M8 bolts to secure the clamp; insert the bolts from the top and turn clockwise with the included hex key to tighten. For a secure fit, use the included rubber mats between the clamp and the bar. 3. Slide the speaker onto the clamp from below. 4.
Wiring the speakers To access the speaker and LED wire terminals, remove the panel on the top of the speaker housing, behind the mounting bracket. Speaker signal wiring To send signal to the speaker, thread the speaker wire from the mounting bar through the lower half of the mounting bracket, then connect the positive(+) and negative(-) leads to the appropriate speaker terminal. Press the spring-loaded terminal in, insert the bare wire end into the slot, then release the terminal.
Attaching the safety strap To keep the speaker from falling when adjusting it, use the included safety strap. Wrap the loop around the horizontal bar of the wake tower, then secure the strap to the speaker by threading the included hex screw through the strap's ring, and screwing it into the hole on the side of the mounting sleeve. Wrap around tower bar Protecting your speaker from the elements When not in use, you can protect your speaker using the included neoprene bag.
CA_JBL_Tower X Marine Speaker_OM_PV_V2 17
