Owners Manual
5
Power/Protect indicators
The power light will illuminate in green when the amplier is getting
power and playing. The light will illuminate in red if the amp enters
protect mode in the event of conditions such as over/under voltage,
short circuit, amplier output circuit failure, or excessive heat.
POWER
PROTECTION
Battery
Remote turn-on (to stereo)
Fuse holder
Chassis ground
(-)
SIGNAL INPUT
• Line-level inputs: If your source unit oers preamp outputs,
connect to the amplier’s L and R preamp inputs using RCA patch
cables.
• High-level inputs: If your audio system’s source unit does not
have line-level outputs, use the supplied high-level input adapters
to connect to either the front or the rear speaker output wires of
your source unit. Use solder, butt connectors, or your preferred
splicing method. The 12-volt DC oset feature will turn the
amplier on when it senses signal.
• Input level selection: If you’re sending signal to the amplier
using low-level outputs from your source unit, slide the input level
selector to “LO.” If using high-level outputs from your source unit,
slide the selector to “HI.”
HI LO
INPUT
LEVEL