Data Sheet

PRX835W
Features:
< Maximum SPL Output 138 dB Peak
< 15” Differential Drive
®
low-frequency drivers for low-
distortion and higher SPL
< 1.5” diameter next generation JBL neodymium
compression driver
< 1500W (dual 750 watt) highly efcient Class-D
amplier
< Normal and Boost user selectable EQ presets
< DSP input section, crossover, dynamic limiting,
component optimization, selectable system EQ
< Wireless remote control of its onboard DSP EQ
parameters via Wi-Fi. Control and congure your
show from anywhere.
< Professional XLR-1/4” combination inputs, RCA
inputs, and XLR loop-through
< Integrated 9 x M10 suspension points
< Lightweight poplar plywood cabinets made structurally
sound with tongue and groove joints and protected by
JBL’s tour proven DuraFlex™ nish
Application:
< This speaker is ideally suited to applications where
the program material exhibits subtlety and nuance.
Perfectly capable of reproducing high delity full
range sound without a subwoofer, when coupled with
the extended low frequencies of the PRX818XLFW,
complete control over the entire audio spectrum
is attained. As with all the full-range PRX800
Series systems, two EQ selections can be used to
optimize the system for the program material and/or
environment. The input section also accommodates
either Line or Mic/Instrument level inputs.
< The PRX835W is a self-powered, lightweight three-
way loudspeaker system capable of delivering a very
high level of performance over a wide bandwidth
with remote Wi-Fi control of onboard DSP EQ
parameters. The PRX835W is comprised of one 15
in 275G Differential Drive
®
woofer, a 165 mm (6.5
in) 196H horn-loaded mid-range and a 2408H-2 37.5
mm (1.5 in) annular polymer diaphragm, neodymium
compression driver mounted to a 90° by 50° horn,
all driven by a 1500 watt Audio Class-D power
amplier. Sophisticated DSP is at the core of a fully
featured input section, providing user selectable
system EQ, protection, input sensitivity selection,
cross-over functionality, dynamic limiting and discrete
component optimization.
< All PRX800 cabinets are built from a combination
of 25 mm (on the top and bottom for added rigidity)
and 18 mm, strong, light-weight poplar plywood made
structurally sound with tongue and groove joints.
All PRX800 Series cabinets are protected by JBL’s
tour proven DuraFlex™ nish. Grilles are made
from dent-resistant 16 gauge steel and handles are
made from light-weight glass-lled nylon for added
strength and durability. All M10 suspension points are
constructed from 14 gauge steel and have been tested
with a yield-strength of 1000 lbs. each.
< The amplier input panel offers XLR or ¼ inch jack
compatibility and a sensitivity switch provides extra
exibility, making it possible to connect literally any
sound source without using a mixer. Signal present
and overload lights indicate the system status and
assist in setting the optimum level via the level control
knob.
Specifications:
System:
System Type: Self Powered 15”, three-way, bass-reex
Maximum SPL Output: 138 dB peak
Frequency Range (-10 dB): Normal: 41 Hz – 20 kHz
Boost: 41 Hz – 20 kHz
Frequency Response (±3 dB): Normal: 50 Hz – 18.25k
Boost: 48 Hz - 20k
Input Connectors: 2 x Balanced XLR / 1/4 inch input, 2 x unbalanced RCA input
Input Impedance: 20K Ohms (balanced), 10K Ohms (unbalanced)
Signal Indicators: Limit: Yellow LED indicates peak output has been reached and
dsp limiter is acting
Signal: Green LED indicates signal present
Power: Blue indicates system has power and ready to pass audio.
EQ: User selectable presets for Normal or Boost, Advanced EQ
settings available using Wi-Fi and PRX Connect application.
Dynamic Control (Input): dbx Type IV™ limiter circuit
Crossover Frequency: 580 Hz, 2.1 kHz
Amplifier:
Design: Highly efcient Class-D amplier
Power Rating: 1500W (750W x 2)
AC Power Input: 100V - 240V ~ 50/60 Hz
Speaker:
LF Driver: 1 x JBL 275G 380 mm (15 in) woofer
MF Driver: 1 x JBL 196H 165 mm (6.5 in) horn-loaded midrange transducer
HF Driver: 1 x JBL 2408H-2 37.5 mm (1.5”) annular polymer diaphragm,
neodymium compression driver
Coverage Pattern: 90° x 50° nominal
Directivity Index (DI): 10.5 dB
Directivity Factor (Q): 11.2
Enclosure: Trapezoidal, 18 mm, plywood
Suspension / Mounting: 12 x M10 Suspension Points
Transport: 2 x integrated handles with injection molded backing cup
Finish: Obsidian DuraFlex™ nish
Grille: Powder coated, Obsidian, 16 gauge perforated steel with acoustical
transparent black cloth backing.
Dimensions (H x W x D): 938 mm x 446 mm x 539 mm
(36.9 in x 17.5 in x 21.2 in)
Net Weight: 34.9 kg (77.0 lb)
Gross Weight: 38.6 kg (85.0 lb)
JBL continually engages in research related to product improvement. Some materials, production methods and design renements are
introduced into existing products without notice as a routine expression of that philosophy. For this reason, any current JBL product
may differ in some respect from its published description, but will always equal or exceed the original design specications unless
otherwise stated.
15” Three-Way
Full-Range Main System