User's Manual

RADIOBAND SYSTEM INSTALLATION MANUAL V2.2 / 3

1. INTRODUCTION

1.1 System description

The Radioband system is designed for installation with a safety edge in garage door

installations.

This system allows for wireless safety edge – control panel connection.

To install this system, you must follow the advice included in this manual and take

the requirements of the applicable normative into account.

1.2 Normative requirements

The directives applicable to this system are:

- 98/37/EC Machines Directive

- 73/23/EEC Low Voltage Directive

- 2004/108/EC Electromagnetic Compatibility Directive

- R&TTE 1999/5/EC Radio and telecommunication terminal equipment

Directive

Below are some of the requirements of the applicable harmonised standards:

In accordance with the European low voltage directive, you are informed of the

following requirements:

· For permanently connected equipment, an easily accessible connection device

must be incorporated into the cabling.

· This equipment must be installed in a vertical position and firmly fixed to the

structure of the building.

· This equipment may only be handled by a specialized installer, by maintenance

staff or by a properly instructed operator.

· The instructions for use of this equipment must always remain in the possession

of the user.

· Terminals with a maximum section of 3.8mm2 must be used to connect the

cables.

- The frequency of the Radioband system does not interfere in any way with the

868 MHz remote control systems. However a signal centred at 868,9MHz may

cause a delay on the reaction of the system.

- Always connect the door structure and metal parts to an earthing connection.

- Do not share the power and signal supply.