User's Manual

ManualsBrandsJCM Technologies ManualsElectronicsPeriodic transmitter used in garage door applications

RADIOBAND SYSTEM INSTALLATION MANUAL V2.3 beta version / 16

INSTALLATION AND CONNECTIONS

Connection to a control panel using a connector for safety devices.

LIGHT INDICATORS

RADIOBAND/R

U-RC-RCS

In operation In programming

Relay 1 LED Normally off.

Indicates the status of the relay output.

If R1 is not connected, on.

On. Indicates the channel to be

programmed.

Relay 2 LED Normally off.

Indicates the status of the relay output.

If R2 is not connected, on.

On. Indicates the channel to be

programmed.

OPERATION

The receiver checks that all the programmed bands are working properly. If a band

is activated or if there is an error in its operation, the receiver activates the output

relay.

MANUAL PROGRAMMING

RADIOBAND/RC-RCS makes it possible to store 6 RADIOBAND/TAs and/or

RADIOBAND/TBXs (3 on Relay 1 and 3 on Relay 2).

Press the receiver programming PROG button for 1s; a sound signal will be heard.

The receiver will enter safety band closing programming mode (BSC). If the

programming button is kept pressed, the receiver will enter safety band opening

programming mode (BSO), moving cyclically from one really to another. Once the

programming relay has been chosen for the transmitter you want to start using,

send the programming code by pressing the transmitter. Every time a transmitter is

programmed, the receiver will emit a sound signal for 0.5s. If 10 seconds pass

without programming, the receiver will go out of programming mode, emitting two

1s sound signals. If, when programming a transmitter, the receiver's memory is full,

it will emit 7 sound signals lasting 0.5s and come out of programming.

Note: For a right operation of the system, the transmitter has to be programmed

in one receiver only.

RADIOBAND/TA, RADIOBAND/TBX replacement: In case you need to replace a

RADIOBAND/TA or a RADIOBAND/TBX, it is necessary to reset the system (see

TOTAL RESET on next page) and reprogram all RADIOBAND/TA and/or

RADIOBAND/TBX used in the installation.

SYSTEM CHECK

This function has to be used to check the operation and range of all the devices

once the installation has been carried out.

Press the receiver’s CHECK button for at least one second to enter check mode.

The indicator light will come on and four beeps will be heard.

Perform a complete door opening and closing manoeuvre. During the system

check a beep will be heard every 1,5 seconds.

CORRECT OPERATION OF THE SYSTEM