Installation Instructions

Miller Edge, Inc. • www.milleredge.com • [e-mail] • East Coast: 800-220-4422 • West Coast: 800-887-3343
7. TRANSMITTER: SPECIFICATIONS & CONTROLS
Transmitter Frequency: 916 MHz, FSK modulation
TX Indicator Lights:
• Green LED: Normally off
• Press program button for status
Mounting: 4 corner screws (provided)
Power Source: Batteries: 2 AA, 3.6V lithium, 2 year life expectancy
Dimensions: 1.80”L x 4.78”W x 1.75”H
Program Button: Momentary push button is used to associate the Transmitter to the Receiver.
8. RECEIVER: SPECIFICATIONS & CONTROLS
Power: 12-24 VAC/DC nominal (11-30 V max); power may be supplied from the operator or alternatively from an
external supply. 100 mA maximum current draw.
Cable Connections: Screw clamp type terminal blocks for 18-26 AWG wire.
Dimensions: 4.12”L x 3.65”W x 1.65”H
Learn Button: Used to associate a Transmitter with the desired receiver channel.
Check Button: Press to determine the signal strength. 4 or 5 blinks is ideal.
RX Indicator Lights:
• Check LED:
1. Blinks every ~5 seconds to indicate working properly
• Channel LED:
1. Off when the associated sensing edge is learned and has no faults
2. On solid: No Transmitters learned or sensing edge is active
Connections:
• Power (2)
• Output:
1. OSE1_2F: Photo-eye output
2. OSE1_3F: High speed pulse output (not commonly used)
3. NC2: Normally Open output for non-monitored applications
9. FCC COMPLIANCE
Transmitter
Model: RB-TX10C
FCC ID: U5Z-RB-TX10C
Receiver
Model: RB-P-RX10C
FCC ID: U5Z-RB-P-RX10C
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference and
2. This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules:
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which may be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
1. Re-orient or relocate the receiver antenna
2. Increase the separation between the equipment and the receiver
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
4. Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment.
DRAFT
This device complies with the FCC RF exposure limits and has been evaluated in compliance with mobile exposure conditions.
The equipment must be installed and operated with minimum distance of 20 cm of the human body.