User's Manual

1248xxx_Rev0.0 RB3 OSE916 Page 4/4
Maintenance
Total reset
In programming mode, keep the programming PROG button pressed down and make a bridge with the “MR” reset jumper for 3s.
The receiver will emit 10 warning sound signals and then more at a faster frequency, indicating that the operation has been carried
out. The receiver will stay in programming mode.
If 10 seconds pass without programming a transmitter, the receiver will exit the programming mode, emitting two 1 sec beeps.
Replacing a transmitter
If a transmitter becomes damaged the whole system must be reset and replaced, and non-damaged transmitters must then be re-
programmed into the receiver.
Important Annex
Disconnect the power supply whenever you proceed to the installation or repair of the control panel.
In accordance with the European low voltage directive, you are informed of the following requirements:
· For permanently connected equipment, an easily accessible connection device must be incorporated into the cabling.
· This system must only be installed by a qualified person that has experience with automatic doors/gates and knowledge of the
relevant EU standards.
· The instructions for use of this equipment must always remain in the possession of the user.
· Terminals with a maximum section of 3.8mm2 must be used to connect the cables.
Follow all the recommendations given in this manual to avoid serious dangerous to persons.
Regulations
EC Declaration of conformity
See web www.jcm-tech.com/en/declarations/
JCM TECHNOLOGIES, S.A. declares herewith that the product RB3 OSE916 complies with the requirements of the 1999/5/ CEE
R&TTE Directive, and complies with the fundamental requirements of the 2006/42/CE Machine Directive, 2004/108/EC Directive
on electromagnetic compatibility and 2006/95/EC on low voltage, insofar as the product is used correctly.
The system complies with EN ISO 13849-1:2008, category 2, PLd.
FCC Information
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
IMPORTANT! Any changes or modifications not expressly approved by the part responsible for compliance could void the user’s
authority to operate this equipment.