User Guide

Appendix A – Web Xpander Commands
Command Description Example
:reset=
Resets the Web Xpander
:reset=
:factory=
Load factory default
values (follow with
:reset= to restart
with these values)
:factory=
(then optionally) :reset=
:ipaddr=
Sets the IP Address
:ipaddr=192.168.0.20
:ipmask=
Sets the Netmask
:ipmask=255.255.255.0
:ipgate=
Sets the Gateway Addr.
:ipgate=192.168.0.1
:dns=
Sets the DNS Address
:dns=192.168.0.1
:dhcp=
Enabled/Disables DHCP
:dhcp=1
:smtp=
Sets the outgoing
(SMTP) mail server
:smtp=smtp.comcast.net
:user=
Sets the user name
required for access
:user=myname
:pass=
Sets the password
required for access
:pass=mypass
:webport=
Sets the port (default =
80) for the web server
:webport=80
:telnet=
Sets the port (default =
23) for
telnet (Ethernet to
Serial)
:telnet=23
:time=
Sets the internet Time
server for time
synchronization
:time=time-b.nist.gov
:daily=
Sets the daily time sync
in number of minutes
from midnight
:daily=210
(i.e. 3:30am)
:netinfo=
Displays network
settings
:netinfo=
:mailto=
Sets a email recipient –
Can be sent up to 5
times per message to
indicate up to 5
recipients
:mailto=[e-mail]
:mailto=[e-mail]
:mailfrom=
Sets the email sender
:mailfrom=[e-mail]
:mailsubject=
Sets the email subject
:mailsubject=Test Email
:mailbody=
Sets one or more lines of
email text.
This command can be
sent multiple times up to
500 characters total.
:mailbody=Motion Sensor 1
Activated
:mailsend=
Sends the email
:mailsend=