User Guide

10-pin
programming
connector
Properly attached Rabbit
Programming Cable
Using the Rabbit Field Utility
1. Start the Rabbit Field Utility located on the Start menu in the Web
Xpander folder (labeled WebX Firmware Utility)
2. Select S
etup, Communications from the main menu
3. Select “Use S
erial Connection”, Baud Rate: 115200, and the COM port
you have attached the programming cable to.
4. Uncheck both check boxes labeled “Enable Processor Detection” and
“Use USB to Serial Converter”
5. Click OK to save these changes and return to the main window.