Instructions / Assembly

3. Periodically change water and keep water clean. We recommend distilled water to prevent mineral build-up.
This instruction relates ONLY to this water fountain product and contains important information for
using the product for the first time. Please keep it for later reference. This instruction should always
accompany the product in the event of transfer to a new user.
3. Make sure the water tube is properly connected with the pump and the upper layer, and do not crimp the tube otherwise
water will not come out.
4. During operation, the area around the pump will be covered with water. Take care when handling the pump; do not pull
pump out of water (when running) by the power cord, and do not move the product when running.
5. Unplug pump and power before servicing, cleaning, or moving.
Cleaning and Maintenance:
1. If after time the pump starts to lose power or stops working you should check for the build up of sediment or scale at
the bottom of the pump housing or in reservoir.
2. Remove the impeller or any dirt and scale, which has built up and close the case back up.
2. Do not pump flammable liquids such as gasoline / fuel oil with the fountain pump.
Safety Guidelines:
1. Read all instructions and safety guidelines thoroughly. Failure to follow guideline and instructions could result in
serious injury and/or property damage.
INTRODUCTION
INSTRUCTION MANUAL
Product Feature: The product consists: (1)Gnome (2) Fountain base (3)Pump
(Please read pump user manual).
Instructions for use:
Thank you for purchasing this fountain. You have purchased a product that complies
with the latest design and with a creative theme.
This product is carefully packaged, inspected, and tested to ensure safe operation and
delivery. The following instructions and safety guidelines will enable you to use the
product for trouble-free operation. Please read the insturctions and safety guidelines
entirely before using the product.
1.Unpack the product. Read this instruction sheet before proceeding.
2.Familiarize yourself with the pump. The pump speed is controlled
by the switch located at the front of the pump. The speed is
indicated by plus(+) and minus (-) sign. To increase the speed, move
to each speed level. At its highest speed level, the switch will cease to
move any further, vice versa.
3.Place the product on a flat surface, remove plastic bag from
packaging.
4.Insert the pump into the water tube from the fountain body, then
connect the male jack with female jack.
5.Fill base pond with tap water to 1cm from the edge of the base.
Make sure there is no solid impurity in the water, or it will affect the
pumps work;