Use and Care Manual

ASSEMBLY INSTRUCTION

Warning:

1. OUTDOOR USE ONLY!

2. Do not use this unit on a wooden deck or on combustible surfaces such as dry

grass, leaves, mulch, etc.

3. Do not use this unit near heat sensitive or combustible structures such as vinyl or

wood siding.

4. When in use, keep the fire pit area clear and at least 60 cm(24inch) side clearance

from combustible materials, gasoline and other flammable liquid and vapors.

5. DO NOT use gasoline or kerosene. Use only a method of lighting, which is

acceptable. This unit has been designed for burning of charcoal and untreated

Wood only. Do not place burning material over 75% of the full capacity for safe use.

6. NEVER LEAVE FIRE UNATTENDED! Do not allow small children near flame. Hot

embers can fly out of basin in breezy conditions. Adequate fire extinguishing material

should be readily available.

7. CARBON MONOXIDE HAZARD

i. Burning charcoal inside can kill you. It gives off carbon monoxide, which has

no odor.

ii. NEVER burn charcoal inside, vehicles or tents.

8. Do not use this fire pit as a cooking appliance. This FIRE PIT is not designed to be

used for grilling food. Eating food cooked in this FIRE PIT could cause poisoning and

death.

9. Do not attempt to move your fire pit while hot or in use.

10. Some parts may contain sharp edges – especially as noted in manual. Wear protective

gloves if necessary.

1/3

PAGE 1
ASSEMBLY INSTRUCTION Warning: 1. OUTDOOR USE ONLY! 2. Do not use this unit on a wooden deck or on combustible surfaces such as dry grass, leaves, mulch, etc. 3. Do not use this unit near heat sensitive or combustible structures such as vinyl or wood siding. 4. When in use, keep the fire pit area clear and at least 60 cm(24inch) side clearance from combustible materials, gasoline and other flammable liquid and vapors. 5. DO NOT use gasoline or kerosene. Use only a method of lighting, which is acceptable.
PAGE 2
Hardware list Item Description AA M6 Bolt BB M6 Nut Figure Quantity 12 1 Parts list Item Description Quantity A Lift handle 1 B Mesh screen 1 C Log grate 1 D Fire bowl 1 E Leg 4 F Décor section 1 2 G Décor section 2 2 H Poker 1 Assembly instruction Please save this manual for future reference. Caution: Read, understand and follow all instructions before using this fire pit. Account for all parts and hardware before beginning assembly.
PAGE 3
Step2 Turn Fire bowl (D) upside down firstly, connect 4 Legs (E) with Fire bowl (D) by using bolts (AA) loosely, then connect 2 Décor section 1 (F) & 2 Décor section 2 (G) to 4 Legs (E) by using Bolts (AA) loosely. See Figure 2. Tighten all of the bolts, and turn over the assembled parts. Figure 2 Step3 Place Log grate, Mesh screen on the bowl. See Figure 3. Figure 3 Now, your fire pit is ready for use. Please use the Poker (H) provided to lift the screen when you are using this fire pit.