Instruction Manual

4 LOW to 4 HI

With the vehicle at speeds of 0 to 3 mph (0 to 5 km/h),

key ON or engine running, shift the transmission into N

(Neutral), andraise the transfer caseT-handle. The “4WD

LOW IndicatorLamp” in the instrument cluster will flash

and go out when the shift is complete. Release the

T-handle.

NOTE: If shift conditions/interlocks are not met, or a

transfer case motor temperature protection condition

exists, a “CHECK SHIFT PROCEDURES” message will

flash from the EVIC (Electronic Vehicle Information Cen-

ter). Refer to “Electronic Vehicle Information Center

(EVIC)” in Section 4 of this manual. (See page 184 for

more information.)

NOTE: Shifting into or out of 4WD LOW is possible

with the vehicle completely stopped, however difficulty

may occur due to the mating clutch teeth not being

properly aligned. Several attempts may be required for

clutch teeth alignment and shift completion to occur. The

preferred method is with the vehicle rolling 0 to 3 mph (0

to 5 km/h). If the vehicle is moving faster than 3 mph (5

km/h), the transfer case will not allow the shift.

Shifter T-Handle

STARTING AND OPERATING 267