Instructions / Assembly

INSTALLATION INSTRUCTIONS
for Interior Door Slabs (JII110)
4
Please visit jeld-wen.com for warranty
and care and maintenance information.
Thank you for choosing
©2014 JELD-WEN, inc.; This publication and its contents are owned by JELD-WEN, inc. and are protected under the U.S. Copyright Act and other intellectual
property laws. All trademarks, service marks, logos and the like (whether registered or unregistered) are owned or controlled by JELD-WEN, inc. or others.
Unauthorized use or duplication of JELD-WEN intellectual property is prohibited.
JELD-WEN reserves the right to change product specications without notice. Please check our website, jeld-wen.com, for current information.
(12/14)
COMPLETE INSTALLATION
4
INSTALL LOCKSET AND FINISH INSTALLATION
1. The center of the
hole for the lockset
is usually 44" from
the top of the slab
and either 2 3/8" or 2
3/4" on center from
the edge, depending
on the latch. For
slabs that have
a rail (horizontal
member) across the
center of the slab,
the lockset should
be centered in this
rail. Using the lockset
manufacturer's
instructions and
template, drill for
lockset. Generally, a 2 1/8" diameter hole is needed for the lockset.
Drill a 1" latch hole through the edge of the slab into the center of
the lock hole to accommodate the latch for the lock. Some latches
have a radius (rounded corners) or rectangular face plate that will
require the slab edge to be chiseled for t. Drill pilot holes for
attachment screws. Other latches are round (contractor drive-in) and
can be tapped into place with a hammer.
Lockset
hole
Rail
Panel
Latch
hole
2 3/8"
2. Close slab and check for proper operation. Adjust as necessary.
3. Finish all surfaces of the slab if not already done.
4. If installing a solid
core, custom carved,
or stile and rail slab,
install a #9 x 2 1/2"
screw in the center
hole (as shown) in
the top two hinges
(through the leaves
toward the jamb).
Jamb
Replace with
longer screw