Operating Guide

PRODUCT GUIDE
Aluminum Single-Hung Windows (JPG002)

SASH REMOVAL & INSTALLATION - CONTINUED
SPIRAL BALANCE - CONTINUED
0QFOXJOEPXBMMUIF
way; this releases
most of the tension
in the balance
springs.
"EFRVBUFMZTVQQPSU
the sash until
fully removed or
reinstalled.
*OTFSUUIFBEKVTUNFOU
tool into the small
hole on the bottom
of the spiral rod.
1VMMUIFTQJSBMSPE
EPXOBCPVUBOE
slowly allow the rod
to unwind. Repeat
for the opposite side.
9. Lower the sash to the bottom and remove the screw from the top of
one of the balances. Remove the balance.
4MJEFUIFTBTIUPUIFTBNFTJEFUIFCBMBODFXBTSFNPWFEBOE
remove sash.
Installation
*OTUBMMOFXMPDLPOUPTBTIJGUIFMPDLXBTCSPLFOPSUIFTBTIEPFTOhU
have a lock already installed.
4MJEFUIFBQQSPQSJBUFTJEFPGUIFTBTIJOUPUIFKBNCUIBUIBTUIF
balance still attached.
*OTFSUPQQPTJUFTJEFPGTBTIJOUPKBNC
4. Push sash up into open position.
4MJEFCBMBODFJOUPUIFHSPPWFCFUXFFOUIFTBTIBOEKBNCVOUJMUIF
bottom of the balance is ush with bottom of sash.
6TFUIFCBMBODFBEKVTUNFOUUPPMBOEUVSOUIFSPEDMPDLXJTFTJY
complete turns and reattach to the bottom corners of the sash.
Repeat for opposite side.
7. Snap guide blocks into place and attach them with screws.
0QFODMPTFBOEMPDLXJOEPXJGTBTIEPFTOPUGVODUJPOQSPQFSMZZPV
NBZOFFEUPSFBEKVTUUIFCBMBODFXJUIUIFCBMBODFBEKVTUNFOUUPPM
If sash still does not function properly, remove and reinstall.
FIXED SASH
These steps only apply to windows with a xed upper sash. They do not
apply to direct set glass.
Removal
3FNPWFPQFSBUJOH
sash as noted
above.
2. From the exterior,
remove screws
located on the
bottom rail of the
xed sash.
4MJEFTBTIEPXOIBMG
way.
4. Push sash toward
POFTJEFKBNCVOUJM
it is clear of the
PQQPTJUFTJEFKBNC
and remove sash.
Installation
To install, reverse
removal steps as noted
above.
BALANCE REPLACEMENT & ADJUSTMENT
A balance system controls the movement of a sash in a single-hung
window. Balance systems are under tension; replace with caution. If
you need help determining if the window needs a new balance, call
our service department. Order the same balance type and specify the
sash size. Balances are designed to support different sash sizes. A large
sash requires a different balance than a smaller sash. A properly tting
balance will be the correct length, hold the sash weight, and t with all
other components. If a balance needs to be replaced, we recommend
replacing all balances in the window at the same time. Read and
understand all instructions before beginning.
There are two types of balance systems; block and tackle, and spiral.
The block and tackle t
balance is encased in
a metal sleeve and
used on windows
with metal take-
out clips in the side
KBNCT5IFTFCBMBODFT
BSFOPUBEKVTUBCMF
and may have slight
differences.
The spiral balance t
is a spiral-shaped
rod extending
from a steel tube
down into a clip
attached to the sash.
Spiral systems are
BEKVTUBCMFBOENBZ
CFBEKVTUFEJGOPU
operating properly.
Spiral systems must
CFBEKVTUFEXIFO
replaced for proper
operation.
Fixed sash
attachment
screws
Balance
clip
Balance rod
"EKVTUNFOUUPPM
Sash
Block & Tackle
Balance
Spiral Balance