Installation Guide

INSTALLATION INSTRUCTIONS
for Vinyl Projecting Windows with Integral Nailing Fin (JII023)
5
3. Fasten
window with
agalvanized
roo ng nail
through the
nailing  n
between 3"
and 7" from
one lower
corner.
4.Alignside
jamb shims
with the pre-
drilled holes
so fasteners
will penetrate
shims. Shims
mustbesetbackatleast1/4"fromtheinteriorofthejamb.Secure
shims with sealant.
5.Inspectwindowforsquare,level,andplumb.Testforproper
operation (remove and reinstall if necessary).
6.Using#10x31/2"panheadscrews,fastenthejambs,head,andseat
board through the pre-drilled and countersunk pilot holes. Screws
should penetrate the previously installed shims.
APPLY THE SELF-ADHESIVE FLASHING
Note! Keep the edge of the JELD-WEN self-adhesive  ashing as close to
the window frame as possible.
3. Fold the head
board piece
lengthwise
into “L” shape.
Center and
apply one leg
to head board
and the other
to the wall
above the
rough opening
header. Cut
the corners
to allow the
 ashing to lay
 at against the
wall.
4.Starting2"
above the
header, apply
the side pieces.
5.Centerand
apply the
header piece
above the
header.
6. Press the
 ashing down
with a J-roller.
7. Inspect self-adhesive  ashing for gaps or bubbles (remove and
replace if necessary).
PREPARE FLASHING
1. Cut four pieces of JELD-WEN self-adhesive  ashing as follows:
•Oneheadboardpiece6"longerthantheheadboard
•Oneheaderpiece12"longerthantheheader
•Twosidepieces7"longerthaneachside
SPRAY ADHESIVE/PRIMER
Note! Protect window from overspray.
2. Apply spray
adhesive/
primer as
instructed to
nailing  n,
sheathing and
building wrap
at the sides and
head as shown.
Warning! To avoid injury, use at least two people to install. Temporarily
support the window until fully installed.
Note! Window should be pre-drilled and countersunk before placing
inside the rough opening.
1. Pilot holes
should be
spaced 1 1/2"
from interior
edges,4"from
each corner
and then
evenly spaced
no more than
12" around the
inside perimeter.
Drill 1/8" pilot
holes and
countersink.
2. Place window
onto the drain
mat in the
rough opening.
The window sill
must rest on and be fully supported by the rough opening framing.
INSTALL BAY/BOW WINDOW
5
Countersink
1 1/2"
4"
FLASH BAY/BOW WINDOW
6
S
p
r
a
y
A
d
h
e
s
i
v
e
6"
Fold
down
Cut
3"
2"
6"
6"
2"
3"- 7"
Framing
Shim
Seat board
1/4"
sealant
gap