Manual

INSTALLATION INSTRUCTIONS
AuraLast
®
Exterior Door Frame Assembly Instructions
6
DOOR UNIT INSTALLATION
Applythreeormorecontinuousbeadsofcaulkingtothe
bottomofthesillandsidejambs.
SecureDoorUnittoRoughOpening
Removetemporarystrikejambshimssothedoorwillopen
freely.
Removethetopscrewfromeachhinge.Pre-drillandreplace
witha#8x2-1/2"screw.Thesescrewswillrunthroughhinge
jamb,shim,andintotheroughstud(asillustrated).
Strikejamb,pre-drillpilotholesatthetopandbottomshim
locations.Hidescrewlocationsbehindtheweatherstrip(as
illustrated). 
Checkthedoorunitforconsistentdimensionsbetweenthe
frameanddoor.Addscrewsifneedforsupportandreveal
consistency.Checkweatherstripcontacttomakesurethedoor
surfacehasequalpressurearoundthewholedoor.Makethe
necessaryadjustments.
PlaceDoorUnitinRoughOpening
andShiminPlace
Onhingejamb,shimbehindeachhingeandchecktoensure
thedoorunitisplumb,level,andsquare.
Onstrikejamb,shimthetopandbottomandbehindthelock
setlocation.Checktoensurethedoorunitisplumb,level,and
square.
HingeJamb
Removeshims
#8x2-1/2"
Screws
Shim
Shim
StrikeJamb