Instructions / Assembly
INSTALLATION INSTRUCTIONS
for Vinyl Patio Doors without Nailing Fin (JII015)
6
6
INSTALL PATIO DOOR
Warning! To avoid
injury, use at least
two people to install.
Adequately support
the door until fully
installed.
continuous bead of
sealant across the sill
pan back dam.
2. Tilt patio door into
the rough opening.
Make sure the back
of the door makes
solid contact with the
sealant.
Sealant
only through the
rst interior wall of
clearance hole. Then,
through the jamb
wall, shim and into
the framing.
5. Apply sealant to the
head screw and drive
through the shim
lower corner.
door is square, level, and plumb. Test for proper operation (remove
and reinstall if necessary).
SECURE PATIO DOOR
Note! Apply sealant to screw threads before driving through shims.
Do not over tighten fasteners and do not allow fasteners to deform
the vinyl frame, it must be kept at and straight.
screws through each of the remaining shims.
SHIM THE JAMBS
Note! Secure all shims
with sealant.
3. From the interior,
shim the head and
the corners and
Install shims at the
strike plate so that
strike plate screws
(installed later) will
each penetrate a
shim. Shim so the
door is square, level
and plumb.
7
1. For continuous slab
landings, apply a
around the sill where
it meets the slab.
weep holes as shown.
2. Ensure sealant on
back dam of the sill
pan fully seals to
the inside face of
the sill. Apply more
sealant as necessary
to ensure an airtight
seal.
For Premium vinyl
doors, the bumper
lays over the track
and against the jamb
opposite the operating
panel.
INSTALL BUMPER
For Builders vinyl
series doors, install
the bumper in the
stationary panel side
jamb at vertical center
tapping screw provided.
Builders
Patio Door
Strike
plate
Interior
Bumper
Strike
plate
Interior
Premium
Patio Door
Bumper
Exterior
Framing
Screw
Jamb
Opposing
shims
Strike
plate