User Manual

ManualsBrandsJELD-WEN ManualsFor HomeJII104 Fiberglass Gliding Patio Doors with Applied Nailing Fin

INSTALLATION INSTRUCTIONS

for Fiberglass Gliding Patio Doors with Applied Nailing Fin (JII104)

d. Apply the sill

pan piece of

self-adhesive

ashing over

the sill pan as

shown. The

bottom of the

sill pan should

be sealed by the

ashing.

e. Remove the

upper end

corner of each

side piece, and

for step-down

landings,

remove the

lower end

corner.

f. Apply the

side pieces of

self-adhesive

ashing.

g. Remove the

corners of the

header piece

and apply.

3. Apply sealant across

ashing/masonry

joints at corners of

masonry opening.

4. Apply diamond lath

to all ashed surfaces

to be covered by

stucco.

PREPARE BUCK (MASONRY/BLOCK WALL ONLY)

1. On the exterior, coat the buck and surrounding concrete/masonry

with self-adhesive ashing primer. Follow manufacturer’s instructions

for application procedures.

2. Seal the joint between the buck and the concrete/masonry with

self-adhesive ashing as follows:

Note! Do not allow gaps or bubbles beneath the ashing (remove and

replace if necessary).

a. Cut ve pieces

of self-adhesive

ashing for the

sill, sides, head,

and sill pan as

shown.

PREPARE BUCK

Top

= Remove for step down only

1.5"

Rough opening side jamb +3"

Rough opening head/sill +3"

1.5"

Head/Sill piece

Side piece

b. Apply the sill

piece as shown.

c. Place the sill pan

in the rough

opening.

Sealant