Manual

ManualsBrandsJELD-WEN ManualsFor HomeJII105 Swinging French and Patio Doors

INSTALLATION INSTRUCTIONS

for Swinging French and Patio Doors (JII105)

For Patio Doors:

Pre-drill and install

fourmore#8x3"

screws through the

thick part of the jamb

where shown in a

similar manner to those

installed previously.

Seat all screws fully.

VinylFrenchandPatioDoors:

Note! Use the six screws that come in the hardware pack to install the

door. The hardware pack also contains six screw caps and a #25 torx bit

to install the screws.

1.Verifythedoorislevel,squareandplumb.Checkforevenmargins

around all panels and the frame and that the lockset holes (if

applicable) align properly. If not, adjust shims. Once the screws are

captured in the jamb jacks, they cannot be removed and reinstalled.

Rough

opening

Door

frame

Jamb

jack

INSTALL DOOR - CONTINUED

SECURE THE DOOR

Note! Vinyl door instructions later in this section. All others begin here.

Double door units are shown, however, the fastening instructions also

apply to triple, quad and sidelight French and patio door units.

For French Doors:

Remove a screw from

each hinge next to the

weatherstrip and replace

with one of the provided

#8x3"screws,seating

all screws fully.

ADJUST SILL CAP (IF NECESSARY)

Verifythesweep

properly contacts

the threshold with

1/8" overlap as

shown. Door units

are manufactured

so that, if installed

level and square, the

sweep will contact the

threshold properly,

making adjustments

to the sill cap

unnecessary. However,

if adjustments are

needed, use a at

head screwdriver

to remove screw

covers and turn screw

clockwise to adjust

the sill cap up. Sills are

shipped with sill cap

adjusted all the way

down.

2. Use the jamb jack

screws and TORX

bit (provided) to

initially secure

the frame to the

opening at locations

1 & 2. Turn jamb

jackscrews#1&

#2untiltheyclick

twice. Do the same

for#3.

3. Check the inside

ofjambonthe#1

side for plumb and

adjust by turning

jamb jack screws

clockwise to move

toward the jamb, or

counter clockwise

to move away from

the jamb. Check

unit for plumb,

square and level.

4.Turn#4jambjack

screw until it clicks

twice. Adjust jamb

jack screws on the

#4sidetoplumb

jamb. Again, check

unit for level, plumb

and square.

5.Tightenjambjackscrews#5and#6beingcarefulnottobowtheside

jambs.

6. Check unit for plumb, square and level and adjust as necessary.

Door panel

Threshold

Door panel

Sweep