Manual

INSTALLATION INSTRUCTIONS
for Swinging French and Patio Doors (JII105)
7
Note! Some doors are shipped with a screen track pre-installed. For
those doors, follow these instructions to install the screen system.
If the screen track
was not previously
installed, follow the
instructions provided
with the screen to
install the screen track
and the screen system.
For French Doors:
1. Position smaller
inactive screen on
the inner track at the
top and bottom.
T-ASTRAGAL FLUSH BOLT STRIKE PLATES (FRENCH DOORS ONLY)
To install the T-Astragal
ush bolt strike plates,
follow the instructions
that came with the
product. If they are
missing, complete
the next four steps,
otherwise, skip to
section 8, “INSTALL
SCREEN SYSTEM.”
1. Locate the T-Astragal
attached to the edge
of the inactive door
panel that secures
the panel when the
door is closed. There
are ush bolts at the
top and bottom of
the T-Astragal.
7
INSTALL DOOR - CONTINUED
2. With the inactive
door closed, mark
where the ush
bolts touch the
head jamb and sill
cap.
3. Drill 3/8" holes (1"
deep) at these spots
and apply the strike
plates (provided)
to the sill cap
and head jamb as
shown.
4. With the inactive
door closed, mark
the head jamb
weatherstrip with
a sharp utility knife
at the edge of the
T-Astragal where
it touches the
weatherstrip. Open
the inactive door
and cut through
the weatherstrip
so that when the
door is closed the
weatherstrip clears
the T-Astragal.
8
INSTALL SCREEN SYSTEM
Inner screen track
2. Secure inactive screen
to the side jamb with
2oftheprovided#8
x 3" screws through
the pre-drilled screen
edge holes.
Head
Sill
T-Astragal
Caulk
Cut here
Weatherstrip
T-astragal
Weatherstrip
T-astragal