Installation Guide

Needed Materials
NOTE: JELD-WEN exterior window and door products should be
installed in accordance with JELD-WEN’s recommended installation
directions, which are shipped with the products or can be found on
our website: www.jeld-wen.com. Note that alternative installation
methods and ashing systems may be utilized at the installer’s or
owner’s discretion and, in such situations the installation should be
done in accordance with the ashing manufacturer’s instructions.
Follow all material manufacturer’s instructions for proper use and
compatibility. When using ashing, spray adhesive/primer, sealant
and foam products, we recommend using the same manufacturer
and verifying compatibility. It is the End User’s responsibility to
determine if dissimilar materials are compatible to the substrates in
the application.
NOTE: On Siteline Impact casement and awning windows, fasten through
the provided clip and nail n with (1) #8 x 1-1/2" screw that penetrates
into the structural member.
• 1-3/4" galvanized roong nails (nailing n windows). Nails must
penetrate at least 1-1/4" into framing (or as required by local code).
• #8 x 1-1/2" corrosion-resistant, pan head screws. Screws must
penetrate at least 1" into framing (or as required by local code).
• Galvanized drip cap (or factory supplied).
• Sealant: We recommend OSI
®
QUAD
®
Max Sealant or equivalent. This
can be used in any application and can be painted or ordered in a color
matched product, if desired.
• Backer rod 1/8" larger than the widest portion of the gap (used in
conjunction with sealant bead).
• Polyurethane low expansion Window and Door foam: We recommend
OSI
®
QUAD
®
Foam or equivalent.
• Non-compressible or non-water degradable shims.
For Mulled Units On The Sill:
• Masonry clips.
• #8 x 1/2" screws for fastening masonry clips to the window.
• #8 screws for attaching masonry clips to structure. Screws must
penetrate at least 1" into framing.
Needed Tools
• Utility knife
• J-roller
• Hammer
• Tape measure
• Caulking gun
• Level (4' minimum recommended)
• Drill with 1/8" tapered bit
and3/8" countersink
• Screwdrivers
• Finish hammer or pneumatic
nish nail gun
• Pencil
• Nail set
• Miter saw
MATERIALS AND TOOLS
REMOVE PACKAGING AND INSPECT WINDOW
1
Remove Packaging
Remove shipping materials such as corner covers, shipping blocks or pads.
If there is a protective lm on the glass, do not remove it until installation
and construction are complete. Cut off any staple legs exposed on the side
of theframe.
NOTE: Double-hung windows may have banding on the interior of the
unit. Do not remove until the window is secured in the opening to help
keep the sash in place and the unit square.
Inspect Window
• Cosmetic damage.
• Product squareness (diagonal measurements not more than
1/4"different).
• Correct product (size, color, grid pattern, handing, glazing, energy-
efciency requirements, etc.).
• Drip cap that extends the length of the exterior trim plus 1/8" overhang
on each end (all units require a drip cap); drip cap may or may not be
pre-installed.
• Splits, cracks, holes, missing sections or other damage to the nailing n
longer than 6" and/or within 1/2" of window frame.
• If any of the above conditions represent a concern, or if you expect
environmental conditions to exceed the window’s performance
rating, do not install the window. Contact your dealer or distributor
forrecommendations.
Installation Instructions
for Wood/Clad Wood Windows with Exterior Trim or Nail Fin (JII024)
3