Use and Care Guide

Care and Maintenance
Wood Windows and Patio Doors (JCM003)
12/28/185
Cleaning and lubrication help to maintain and restore smooth operation to movable parts of windows and patio doors and, in most cases, offer corrosion
protection. Always thoroughly clean hardware before lubricating.
CLEANING GLASS - CONTINUED
HARDWARE CLEANING AND LUBRICATION
HARDWARE CLEANING
Stubborn Stain Removal
Commercial glass cleaning products may be necessary.
• Apply small amount directly to the stain. Avoid spilling or dripping
down the glass.
• Some persistent stains may need higher strength cleaning solutions
that contain active ingredient chemicals such as denatured alcohol or
acetone. Special care must be taken when using these types ofcleaners.
• For oil and grease: try baking soda and water or washing soda
andwater.
More Information on Glass Cleaning
• The Glass Association of North America (GANA):
www.glasswebsite.com
• Cardinal Glass Industries: www.cardinalcorp.com
NOTE ON WEBSITES: Website content is subject to change and
should be used for informational purposes only. JELD-WEN is not
responsible for third-party information.
Maintain hardware any time windows are not opening or closing properly
or at least bi-annually (monthly for coastal areas) for:
• Clean dirt/debris
• Tighten loose screws
• Replace damaged hardware
Precautions
The following substances may damage protective hardware nishes. Do
not use:
• Vinegar-based cleaners
• Citrus-based cleaners (lemon, etc.)
• Paint removers
• Window cleaners
• Brick/siding washes
• Any other industrial or abrasive cleaners
Use caution with silicone-based sprays. Apply only in small amounts
and do not overspray. Wipe off excess lubricant to avoid staining and/or
damage to other window or patio door parts. Silicone may cause some
hard plastic parts to become brittle and cause problems with nishing or
renishing wood surfaces.
Hardware Types
Metal hardware offers functionality, aesthetic appeal and resistance to
corrosion, but is not totally corrosion proof. Replace corroded hardware.
Plastic hardware offers high resistance to the elements; however,
over time, can deteriorate from ultraviolet light, heat, cold, and
chemicaexposure.
Brass hardware has a special protective lm to reduce/eliminate
polishing and requires special care.
General Cleaning
1. Remove hardware for easier cleaning.
2. Use mild soap and water on a soft cloth or sponge; rinse and wipe
dry. For stubborn dirt, use a soft bristle brush to gentlyscrub.
3. Apply several coats of high quality, non-abrasive car wax.
4. Reinstall hardware.
Tarnish Cleaning (Brass Hardware)
This section does not apply to brass-plated hardware. The following
cleaning and polishing procedure is recommended by a brass
hardwarecompany.
1. Carefully remove hardware.
2. Gently clean with extra ne steel wool (No. 0000) soaked in light oil
or mild soapy water.
For tough-to-clean brass hardware:
a. Soak overnight in lacquer thinner or paint reducer.
b. Dry completely.
c. Apply brass polish to dry hardware (follow instructions on
manufacturer’s label).
d. After polishing, apply several coats of high quality, non-abrasive
car wax.
e. Prolong nish with follow-up wax applications.
3. Reinstall hardware.
Heavy Cleaning
Solvents, abrasives and other cleaners could cause damage to protective
coatings on hardware. If the general cleaning procedure is not sufcient,
call us for recommendations.