Installation Instructions

ManualsBrandsJELD-WEN ManualsDoorsBuilders Series 81" Wide x 50" High Single Hung Vinyl Bay Window with Colonial Grids - White/White

MATERIALS AND TOOLS

INSPECT PRODUCT

for Vinyl Bay/Bow Windows with Integral Nailing Fin (JII-90025)

Needed Materials

NOTE: JELD-WEN exterior window and door products should be

installed in accordance with JELD-WEN’s recommended installation

instructions, which are printed on the product label or can be found

on our website: www.jeld-wen.com.

NOTE: Alternative installation methods and ashing systems

may be utilized at the installer’s or owner’s discretion and, in

such situations, the installation should be done in accordance

with the ashing manufacturer’s instructions. Follow all material

manufacturers’ instructions for proper use and compatibility.

When using ashing, spray adhesive/primer, sealant and foam

products, we recommend using the same manufacturer and

verifying compatibility. It is the End User’s responsibility to

determine if dissimilar materials are compatible with the

substrates in the application.

• #10 pan-head or washer head, corrosion resistant fastener. Minimum

embedment of 1 1/4" into the structural framing (or as required by

local code).

• 4", 6" or 9" wide self-adhered ashing: We recommend OSI

Butyl

Flash Tape or equivalent.

• Sealant: We recommend OSI

QUAD

Max Sealant or equivalent (for

interior air seal). This sealant can be used in any application and can be

painted or ordered in a color matched product if desired.

• Polyurethane low expansion Window and Door foam: We recommend

OSI

QUAD

Foam or equivalent (for interior air seal).

• Backer rod: 1/8" larger than the widest portion of the gap (used in

conjunction with sealant bead for interior air seal).

• Non-compressible or non-water degradable shims.

Potential Needed Tools

• Utility knife/shears

• J-roller

• Hammer

• Tape measure

• Caulking gun

• Level (4' minimum recommended)

• Drill with tapered bit and 3/8"

countersink

• Pry bar

Remove Packaging

• Remove shipping materials such as corner covers, shipping blocks,

shrink wrap or pads. If there is a protective lm on the glass, do not

remove it until installation and construction are complete.

• Do not remove the installation label until after the inspection of the job

iscomplete.

Inspect Window

• Cosmetic damage.

• Product squareness (diagonal measurements not more than

1/4"different).

• Correct product (size, color, grid pattern, handing, glazing, energy-

efciency requirements, etc.).

• Cracked frame welds or other frame damage.

• Splits, cracks, holes, missing sections or other damage to the nailing n

longer than 6" and/or within 1/2" of the window frame.

If any of the above conditions represent a concern, or if you expect

environmental conditions to exceed the window’s performance

rating, do not install the window. Contact your dealer or distributor

forrecommendations.