Use and Care Guide

CARE AND MAINTENANCE
Interior and Exterior Doors (JCM005)
4
Cleaning and lubrication help to maintain and restore smooth operation to movable parts such as hinges and locksets and, in most cases, offers some
corrosion protection.
GENERAL CLEANING
Prepare cleaning solution (1 tsp. baby shampoo or mild soap to one
gallon of water).
1. Rinse surface with clean water from top to bottom.
2. Apply cleaning solution with a sponge or soft brush with uniform
pressure horizontally, then vertically.
3. Promptly rinse thoroughly with clean water (sponging while rinsing
may be helpful; do not allow cleaning solution to dry on the surface
or collect and puddle).
4. Wipe dry with lint-free dry cloth.
5. If necessary, repeat steps above until clean.
6. Dry door with separate cloth.
PAINT REMOVAL
1. Soak dried latex paint drips with warm water and baby shampoo
solution. For oil-based paint, consult a paint professional.
2. Wipe with damp cloth or sponge.
If needed,
3. Scrape gently with plastic putty knife. Repeat soak and scrape.
4. Repeat if necessary.
LABEL REMOVAL
Slowly peel from one corner. If label tears or sticks, moisten with soapy
water and gently scrape with plastic putty knife. Stubborn labels can
be soaked with soapy water and covered overnight with plastic wrap.
Gently remove with plastic putty knife.
STUBBORN STAIN REMOVAL
Commercial glass cleaning products may be necessary.
• Apply small amount directly to the stain. Avoid spilling or dripping
down the glass.
• Some persistent stains may need higher strength cleaning solutions
that contain active ingredient chemicals such as denatured alcohol
or acetone. Special care must be taken when using these types
ofcleaners.
• For oil and grease: try baking soda and water.
MORE INFORMATION ON GLASS CLEANING
• The Glass Association of North America (GANA):
www.glasswebsite.com
Note on Web sites! Web site content is subject to change and should
be used for informational purposes only. JELD-WEN is not responsible
for third-party information.
Clean door surface and maintain hardware any time doors are not
opening or closing properly or at least biannually (monthly for
coastalareas):
• Clean dirt/debris with mild soap and water and rinse clean
• Tighten loose screws
• Replace damaged hardware
PRECAUTIONS
The following substances may damage protective nishes. Do not use:
• Vinegar-based cleaners (use on glass only)
• Citrus-based cleaners (lemon, etc.)
• Paint removers
• Window cleaners
• Brick/siding washes
• Any other industrial or abrasive cleaners
1. Lubricate hinges with light oil
(3-In-One
®
oil or equivalent)
annually or when noisy.
2. Spray keyway lock with
graphitelubricant.
FOLDING DOORS:
Tracks and Bearings
Wipe visible track surfaces with a damp soft cloth and a mild detergent,
then wipe dry with a clean cloth. Using a suitable applicator spread
a small amount of clear petroleum jelly or similar lubricant where
the carrier wheels pass so that it is distributed evenly along the track.
Place additional lubricant around the bearings. The lubrication reduces
wear, improves operation and protects against corrosion. In severe
environments, apply a thin lm of WD40
®
.
Hangers, Pivots and Brackets
Exposed surfaces should be wiped down with warm soapy water and a
soft rag, and then rinsed clean before applying new surface protectant.
A light spray application of WD40
®
, followed by a light wipe with a dry
cloth to remove any excess.
Hinges
Wipe down the visible surfaces with warm, soapy water and a soft
rag, then rinse off and dry by wiping with a clean rag. Application of
a thin lm of WD40
®
will help maintain the original luster of the metal
nish, and lubricate the moving contact surfaces. Be careful not to get
these compounds on any wood components as it may cause staining.
For oil-rubbed bronze nish, care should be taken when cleaning or re-
applying surface protectant.
Flushbolts
Spray WD40
®
to the sliding pin inside the bolt and to the lock cylinder.
There are access holes or slots on all drop bolts so that this can be
completed without removing the locks from the doors.
CLEANING GLASS
DOOR SURFACE CLEANING AND HARDWARE LUBRICATION