How to Guide

PRODUCT GUIDE
Wood Horizontal Sliding/Gliding Windows (JPG011)
SASH PULL (HANDLE) INSTALLATION
1. Alignsashpull
slightly off
horizontal center
and at vertical
center of closing
stile (the stile that
closes against the
sidejamb).
Note! Do not place
sash pull with screw
holes within 1" of the
visibleglass.
2. Mark stile through sash pull screw holes.
3. Removesashpullanddrillpilotholeswheremarkedwith1/16"drill
bit slightly shallower than screw length.
4. Align sash pull with pilot holes and secure with screws.
SASH LATCH REPLACEMENT
1. Unscrewand
remove latch.
2. Position new latch
in same place and
secure screws.
Stile or rail cladding may be replaced on boot-glazed windows only.
1.Removesash.
Note! Cladding may be secured with either staples or sealant.
2. If secured with staples, pry off staples with stiff putty knife.
3.Ifsecuredwith
sealant, pry cladding
with stiff smooth
tipped putty knife
beginning at
corner to loosen;
do not scratch
woodsurfaces.
4. Slide old cladding
off (if necessary,
pry edge with putty
knife with care to
avoid damage to
wood surfaces).
5. Snap new cladding
onto stile/rail with shorter side in the kerf on the weatherstrip side.
6.Ifnecessary,tap
the end down with
a rubber mallet
and secure with a
smallstapleor1"
bradnail.
7. Prepare new stile/
rail by drilling any
necessary screw
holeswith3/32"drill
bit1/4"shallower
than screw lengths
for screws and/or
hardware (locate
new screw locations
by comparison to old
sash), and transfer
any hardware.
8.Reassemblesash.
9.Applynish/paint
and let completely
dry before
replacingsash.
10.Reinstallsash.
Cladding
Stile/Rail
Weatherstrip
Sash
latch
Sash
pull
HARDWARE REPLACEMENT AND ADJUSTMENT - CONTINUED
CLADDING REPLACEMENT
12/17
5