Operating Guide

PRODUCT GUIDE
Wood Patio Doors (JPG012)
12
Horizontal Adjustment
1. With 5/32" allen
wrench, turn “LOCK”
screws counter-
clockwise in each H
hinge to unlock
2. With allen wrench,
one hinge at a time,
turn screw in “H”
slot in all three
hinges to move
panel side to side to
desiredposition
3. Gently re-tighten
“LOCK” screws
in H hinges to
maintainadjustment.
CURRENT INSWING ADJUSTABLE HINGE
Each door panel will have one vertically adjustable hinge (middle or
lower middle) and the rest will be horizontally adjustable hinges. Never
use a power screwdriver to make adjustments, adjust only by hand with
a 3/32" allen wrench. Make adjustments in 1/4 turn increments and
check position. Stop rotating the adjustment screw once the door is at
its desired location or if the screw becomes tight or stops turning. This
indicates the top or bottom end of the adjustment, do not continue or
you will damage the hinge.
Vertical Adjustment
Remove the weight
from the hinge by
slightly lifting panel
with a pry bar or similar
tool. Rotate the vertical
adjustment screw
clockwise or counter-
clock wise to raise or
lower the door. The
door will move in the
direction of the arrow
next to the adjustment
screw corresponding
to the direction of the
screw rotations.
Horizontal Adjustment
Rotate the adjustment
screw in each hinge
equally. Clockwise
rotations reduce the
reveal of the door at
the hinge side and
counter-clockwise
rotations increase the
reveal of the door at
the hinge side.
To tilt the door:
Adjust the top hinge
the opposite direction
of the bottom hinge.
Horizontal Adjustment Hinge
Adjustment
screw
Vertical Adjustment Hinge
Horizontal Adjustment Hinge
Adjustment
screw
Adjustment
screw
Horizontal
adjustment
screw
Vertical
adjustment
screw inside
HARDWARE REPLACEMENT AND ADJUSTMENT - CONTINUED
OUTSWING ADJUSTABLE HINGE
The outswing adjustable hinge has a horizontal and a vertical
adjustment.
Horizontal Adjustment
1. To move the door
closer to the
hinge side jamb,
turn horizontal
adjustment screw of
each hinge clockwise;
adjust horizontal
screw for each hinge
the same amount.
2. To move the door
away from the
hinge side jamb,
turn horizontal
adjustment screw of each hinge counterclockwise; adjust horizontal
screw for each hinge the same amount.
3. For uneven reveal, adjust either the top or bottom horizontal
adjustment screw until reveal is even.
Vertical Adjustment
Adjustment screw is located at the bottom of the hinge inside
thebarrel.
To lift the door:
1. Turn vertical adjustment Allen screw of the top hinge clockwise; do
not adjust up beyond the top indicator line on the hinge leaf.
2. Tighten (clockwise) vertical adjustment screws of the other hinges to
evenly distribute door load.
To lower the door:
1. Starting with bottom hinge, turn vertical adjustment screw for each
hinge counterclockwise to back out the screw slightly (maybe a
couple rotations); DO NOT remove screw from hinge.
Note! When you get to the top hinge, the door will start to lower.
2. Adjust top hinge to desired height.
3. Tighten (clockwise) vertical adjustment screws of the other hinges to
evenly distribute door load.