Operating Guide

PRODUCT GUIDE
Wood Patio Doors (JPG012)
3
SCREEN REMOVAL AND INSTALLATION AND SCREEN ROLLER REMOVAL AND REPLACEMENT - CONTINUED
These instructions are for the removal and installation of the Truth
patio door screen roller utilized on the JELD-WEN 1350 or 1580
aluminum series screen door.
SCREEN ROLLER REMOVAL
1. Locate the wheel inside
the wheel pocket.
2. Grab the wheel between
your thumb and index
nger and rotate the
wheel assembly upwards
(perpendicular to the
door frame).
a. Note: Due to the
tension of the spring
inside of the frame, a
small amount of force
will be required.
3. Once rotated upwards,
simply lift the roller out of
the wheelpocket.
SCREEN ROLLER INSTALLATION
1. Insert spring into pocket
of frame, opposite of
corner key.
2. Rotate the roller upwards
so that the body of the
assembly is perpendicular
to the door frame.
a. Note: Due to the
tension of the spring
inside of the frame, a
small amount of force
will be required.
3. Push the roller assembly
onto the corner key,
aligning the pivot tabs of
the roller into the pivot
pockets of the key.
4. With roller positioned
into corner pivot pockets,
rotate away from the
corner key and push
the roller down into
theframe.
Wheel
Spring
SLIDING/GLIDING PATIO DOOR PANEL REMOVAL AND INSTALLATION
Because panel removal can be awkward and could cause physical injury
or product damage, we recommend the help of additional people.
Removing the operating panel may be easier if the rollers are rst
retracted, lowering the panel.
OPERATING PANEL
CUSTOM AND POZZI DOORS
1. Close and lock the
operating panel.
2. Gently remove
interior head trim
with small prying
tool being careful
not to damage the
wood.
Note! Do not remove
nails from trim if,
present, unless
necessary. This makes
replacement easier.
3. Remove the operating panel by sliding it away from the side jamb.
Tilt the top of the panel to the interior, remove head track and lift up
and over the sill track.
Interior
head trim
Bumper(s)
Head
stop
Head
track
Screw
Operating
panel
Score
NORCO, CARADCO FRENCH VIEW/FRENCH MANOR, SITELINE AND
W-2500 SLIDING PATIO DOORS
1. Remove bumper(s). Some doors have a bumper in the stationary
panel side jamb and some will have one in the head and sill. This will
allow the operating
panel to open wide
enough to gain
access to the screws
in the head track.
2. Unlock and open
door all the way and
remove the exposed
screws from the head
track with a Phillips
screwdriver.
3. Close and lock
operating panel
to prevent it from
falling out of the
frame opening.
4. Remove screws from
opposite side of the
head track.
5. Unlock operating
panel and carefully
slide open. For
Siteline doors,
lower the panel by
adjusting the rollers
up into the panel.
W-2500 Sliding Patio Doors