Operating Guide

PRODUCT GUIDE
Wood Patio Doors (JPG012)
5
CUSTOM (1996-PRESENT)
Removal
1. Unscrew and remove
the exterior side and
head ller located on
the exterior track of
the operating panel
side and head jamb.
2. Unscrew the
stationary panel clip
in the head jamb
located at the top
of the stationary
panel. This clip was
concealed by the
exterior head ller.
3. Remove the screws in
the sill ller on the
interior side of the
stationary panel.
4. Use a putty knife
to remove the
interior side ller.
The interior side
ller is nailed at 18"
intervals with two,
side by side nails at
each location.
5. Cut the sealant
joint between the
stationary panel and
the side jamb.
6. Slide the stationary
panel towards the center of the unit and remove.
7. To reinstall the panel, perform these steps in reverse order.
Interior
Sill
ller
Exterior
side
ller
Exterior
head
ller
Clip
Frame
Sealant
Interior
side
ller
Panel
SLIDING/GLIDING PATIO DOOR PANEL REMOVAL AND INSTALLATION - CONTINUED
SITELINE AND NORCO SLIDING STATIONARYPANEL
From interior:
1. Remove operating
panel.
2. Unscrew and
remove head and
sill brackets. For the
sill brackets, remove
only the screws on
the panel end of the
brackets. Norco doors
(pre 1995) use a "W"
bracket fastened to
the side jamb and
interior face of the
stationary panel.
From exterior:
3. Slide panel away
from side jamb
while supporting
it on both sides.
Siteline panels must
be slid all the way
toward the operating
paneljamb.
4. Lift and swing
bottom of panel to
exterior and remove.
5. To reinstall the panel, perform these steps in reverse order.
W-2500 AND CARADCO SLIDING STATIONARY PANEL
EXCEPT FRENCH MANOR
From interior:
1. Remove operating panel.
2. Unscrew and
remove head and sill
brackets.
3. Unscrew and remove
security angles (the
brackets fastened to
the sill and interior
face (shown) or edge
of the panel).
4. Unscrew and remove
aluminum interlock.
5. Remove screws from
around panel (these
screws are visible
and go through the
vinyl stop around the
interior side of the
stationary panel).
From exterior:
6. Slide panel away from side jamb while supporting it on both sides.
7. Lift and swing bottom of panel to exterior and remove.
8. To reinstall the panel, perform these steps in reverse order.
Head
bracket
Sill
brackets
Exterior
Interior
Aluminum
interlock
Head
bracket
Sill
bracket