Operating Guide

PRODUCT GUIDE
Wood Patio Doors (JPG012)
6
SITELINE AND CARADCO FRENCH MANOR STATIONARY PANEL
1. Remove operating panel.
2. For clad:
With putty knife,
pry from one edge
and remove plastic
head closure on
the operating
panelside.
3. Unscrew and
remove head ller
from operating
panel side of
headjamb.
4. Unscrew and
remove stationary
aluminum interlock
from stationary
panel stile.
5. Remove head and
sill Allen head bolts
from stationary
panel brackets.
6. Unscrew and
remove stationary
panel head ller
strip from stationary
panel side of
headjamb.
7. Unscrew and
remove stationary
panel head bracket.
8. Unscrew and
remove stationary
side ller strip.
9. Unscrew and
remove center
screw only from
each stationary
jamb-to-stile
bracket.
10. Slide panel away
from jamb, press
bottom towards
exterior while
lifting up, then
remove to interior.
11. To reinstall the
panel, perform
these steps in
reverse order.
Head
ller
Head
closure
Bracket
Head
ller
Side
ller
Frame
Panel
Center
screw
SLIDING/GLIDING PATIO DOOR PANEL REMOVAL AND INSTALLATION - CONTINUED
SITELINE AND W-2500 DOOR WITH FIBERGLASS SILL STATIONARYPANEL
1. Remove the screen by lifting the screen into the head track and then
swing to the exterior
over the sill track.
2. Remove the screws
along the interior
side of the sill that
secure the stationary
panel to the sill.
3. Remove the two
vertical screws in the
head bracket.
4. Slide panel away
from the jamb.
Remove by lifting the
panel and swinging
the bottom out to
the exterior.
5. To reinstall the panel,
perform these steps
in reverse order.
Note! Use a hand
screwdriver to reinstall
screws, power drivers
may strip screws.
Head
bracket
Attachment
screws
Stationary
panel