Installation Guide
INSTALLATION INSTRUCTIONS
for Pre-Hung Exterior Entry Doors (JII106)
3
MATERIALS AND TOOLS - CONTINUED
REMOVE PACKAGING AND INSPECT DOOR 
1
• Plastic drain screen with crisscross or woven pattern (sold in 6" widths 
to protect rain gutters) for step-down landings.
• 3/8" staples for step-down landings.
• Drip cap, if required because of door location and exposure. Doors 
with an adequate overhang (see our Appropriate Protection 
document at www.jeld-wen.com/learn/resources/care-maintenance) 
may not need a drip cap.
For installations into a Buck:
• Liquid applied ashing (Protecto Wrap LWM 200 or equivalent).
For installations into a stud-framed wall:
• 4", 6", or 9" (as required by local code and window conguration) 
wide self-adhered ashing: We recommend OSI
®
 QUAD
®
 Butyl Flashing 
Tape or equivalent. 
NEEDED TOOLS
• Cutting shears (sill 
pan) 
• Tape measure
• Utility knife 
• Level (4 ft. minimum 
recommended)
• J-roller 
• Caulking gun
• Drill with bits
• Construction stapler
• Hammer
• Screwdrivers
• Nail set
• Square
• Pencil
• Pry bar
• Small punch 
ormagnet
REMOVE PACKAGING
Remove shipping materials such as corner covers, shipping blocks 
or pads. Remove any staples exposed on the frame, but leave glass 
protective lms.
1. If the door unit 
includes packaging 
or a skidboard under 
the threshold and 
bottom end of the 
side jamb, remove 
it. If the door comes 
with a security plate 
on the outside of the 
frame at the strike, 
DO NOT remove 
it. Install the door 
with the security 
plateattached.
2. If the door is 
fastened closed 
with a duplex 
nail or removable 
plastic plug, remove 
these along with 
the packaging 
andcrating.
Note! If the door has 
shipping straps, DO 
NOT remove them 
until instructed to 
do so. These hold 
the door system 
aligned and closed 
duringinstallation.
INSPECT DOOR
• Cosmetic damage.
• Product squareness (diagonal measurements must be within 
1/4"difference).
• Correct product (size, color, grid pattern, handing (side the hinges are 
on), glazing, energy-efciency requirements, etc.).
If any of the above conditions represent a concern, or if you expect 
environmental conditions to exceed the door’s performance 
rating, do not install the door. Contact your dealer or distributor 
forrecommendations.
Shipping strap
Shipping strap
Security plate
Skidboard








