Operating Guide

PRODUCT GUIDE
Wood Double-Hung Windows (JPG010)

HARDWARE REPLACEMENT & ADJUSTMENT - CONTINUED
PIVOT PIN/CAM PIVOT/TILT PIN REPLACEMENT - CONTINUED
*OTUBMMOFXQJO
7. Replace sash and test operation. If not operating properly, remove
and reinstall.
OPTIONAL WINDOW OPENING CONTROL DEVICE REPLACEMENT
1. Unscrew and remove
old opening control
device and/or strike
plate.
2. Install new part in
the same orientation
as the old part.
7FSJGZEFWJDF
operates properly.
WEATHERSTRIP REPLACEMENT
Inspecting and maintaining weatherstrip can help avoid costly structural
damage from water leakage and energy loss due to air and/or water
inltration. Replace weatherstrip, that is missing, torn, cracked, brittle,
discolored, gummy, or that has no “bounce back” when pressed down.
Note! When ordering, ask for the same weatherstrip type you have. If
the original is not available, a suitable substitute may be provided.
Determine amount and type needed:
.FBTVSFFBDIQJFDFOFFEJOHSFQMBDFNFOUBEEUPFBDI
measurement.
2. Add all measurements, then add an additional 10%.
3PVOEVQUPUIFOFBSFTUGPPU
4. Call us to order new weatherstrip.
*GQBJOUJOHUIFTBTIBGUFSXFBUIFSTUSJQSFNPWBMNBLFTVSFQBJOUJT
completely dry before installing new weatherstrip.
3FNPWFTBTI
7. Grip and gently pull
existing weatherstrip
from kerf.
Note! On some
windows, there are
two kerfs in the top
and bottom rails;
on the top rail, the
weatherstrip goes in
the interior kerf; on
the bottom rail, the
weatherstrip goes in
the exterior kerf. On the Smart Fit, weatherstrip is located in the head
jamb, check rail, and the sill.
$VUOFXXFBUIFSTUSJQ
to length of existing
XFBUIFSTUSJQ
For sash corners:
a. Press new
weatherstrip into
LFSGXJUI
extending past
each corner.
b. Trim each piece at
corners the same
as old weatherstrip
FJUIFSBUB¡PS¡BOHMFUPåUUJHIUMZBUUIFDPSOFST
For frame:
a. Press new weatherstrip into horizontal kerf at top and/or bottom
PGGSBNFBOEUSJN¡BUFBDIFOE
b. Press new weatherstrip into vertical kerf overlapping horizontal
XFBUIFSTUSJQGPSUSJNNJOH
c. Trim vertical piece to overlap horizontal piece.
d. Reinstall sash.
e. Check window operation, if not operating correctly, remove and
reinstall weatherstrip. If unsuccessful, call us for recommendations.
Opening
control devices
Strike
plates
Lower
sash
Upper
sash
Weatherstrip
Kerf