Operating Guide

PRODUCT GUIDE
Wood Casement & Awning Windows (JPG009)
10
5IFTBTITIPVME
be horizontally
centered in the
frame. If the sash
is too far left or
right, there is a
TJEFBEKVTUNFOU
screw on both the
top and bottom
hinges. Maximum
BEKVTUNFOUJT
reached when
the allen socket
is aligned with
the stay in either
direction. When
UIFTPDLFUJTGBSUIFTUUPXBSEUIFIJOHFKBNCUIFTBTIXJMMCFNPWFE
UPXBSEUIFIJOHFKBNC
4BTINPWFNFOUSFTJTUBODFJTBEKVTUFEPOUIFMPXFSIJOHFXJUIB5
Torx bit. Clockwise rotations increase resistance and counterclockwise
rotations decrease resistance.
*GUIFTBTIXPOUDMPTFPSUIFMPDLJTCJOEJOHBOEOPUGVMMZMPDLJOH
BEKVTUNFOUTUPUIFMPDLJOHQJOTNBZCFOFDFTTBSZ*UNBZCFIFMQGVM
to mark the keepers where the locking pins normally engage with
a marker and then try to close and lock the window. The markings
should be rubbed off where the locking pin is binding. Rotate the
locking pin in small increments in the direction away from the keeper
UPMPPTFO.BYJNVNBEKVTUNFOUPDDVSTFWFSZ
o
in both directions.
Close and lock the window. Repeat until the window will close and
lock without binding.
TILT & TURN CASEMENT WINDOWS
HANDLE REPLACEMENT
1. Place handle in the
turn position.
2. Slightly pull both
ends of the cover
plate out and
rotate 90
o
to expose
screws.
3FNPWFUIFTDSFXT
with a # 2 phillips
screwdriver.
4. Remove handle.
*OTUBMMOFXIBOEMF
in the same position
as the old handle.
LOCKING MECHANISM ADJUSTMENT
1. Verify the
frame is square
before making
BEKVTUNFOUT
Correct out of
square conditions
CFGPSFBEKVTUJOH
hardware.
2. The sash should be
vertically centered
in the frame. If the
sash is too high or
too low, the height
BEKVTUNFOUTDSFX
is in the bottom
IJOHF5PBEKVTU
remove the weight
from the bottom hinge and turn the screw in small increments with a
4mm allen wrench clockwise to lower the sash and counterclockwise
to raise the sash. Center the sash vertically in the frame.
HARDWARE REPLACEMENT & ADJUSTMENT - CONTINUED
Lower Hinge
Upper Hinge
Pressure
BEKVTUNFOU
55PSY
Side
BEKVTUNFOU
4mm allen
Height
BEKVTUNFOU
4mm allen
Locking
pin
Pressure
BEKVTUNFOU
Side
BEKVTUNFOU
4mm allen