Use and Care Guide

CARE AND MAINTENANCE
Wood Windows and Patio Doors (JCM003)
HARDWARE CLEANING
Cleaning and lubrication help to maintain and restore smooth operation to movable parts of windows and patio doors and, in most cases, offer
corrosion protection. Always thoroughly clean hardware before lubricating.
CLEANING GLASS - CONTINUED
HARDWARE CLEANING AND LUBRICATION
STUBBORN STAIN REMOVAL
Commercial glass cleaning products may be necessary.
• Applysmallamountdirectlytothestain.Avoidspillingordripping
down the glass.
• Somepersistentstainsmayneedhigherstrengthcleaningsolutions
that contain active ingredient chemicals such as denatured alcohol
or acetone. Special care must be taken when using these types
ofcleaners.
• Foroilandgrease:trybakingsodaandwaterorwashingsoda
andwater.
MORE INFORMATION ON GLASS CLEANING
• TheGlassAssociationofNorthAmerica(GANA):
www.glasswebsite.com
• CardinalGlassIndustries:www.cardinalcorp.com
Note on Websites! Website content is subject to change and should be
used for informational purposes only. JELD-WEN is not responsible for
third-party information.
Maintain hardware any time windows are not opening or closing
properlyoratleastbi-annually(monthlyforcoastalareas)for:
• Cleandirt/debris
• Tightenloosescrews
• Replacedamagedhardware
PRECAUTIONS
The following substances may damage protective hardware nishes. Do
not use:
• Vinegar-basedcleaners
• Citrus-basedcleaners(lemon,etc.)
• Paintremovers
• Windowcleaners
• Brick/sidingwashes
• Anyotherindustrialorabrasivecleaners
Use caution with silicone-based sprays. Apply only in small amounts and
donotoverspray.Wipeoffexcesslubricanttoavoidstainingand/or
damage to other window or patio door parts. Silicone may cause some
hard plastic parts to become brittle and cause problems with nishing
or renishing wood surfaces.
HARDWARE TYPES
Metal hardware offers functionality, aesthetic appeal and resistance
to corrosion, but is not totally corrosion proof. Replace corroded
hardware.
Plastic hardwareoffershighresistancetotheelements;however,over
time, can deteriorate from ultraviolet light, heat, cold, and chemical
exposure.
Brass hardwarehasaspecialprotectivelmtoreduce/eliminate
polishing and requires special care.
General Cleaning
1. Remove hardware for easier cleaning.
2.Usemildsoapandwateronasoftclothorsponge;rinseandwipe
dry. For stubborn dirt, use a soft bristle brush to gentlyscrub.
3.Applyseveralcoatsofhighquality,non-abrasivecarwax.
4. Reinstall hardware.
TarnishCleaning(BrassHardware)
This section does not apply to brass-plated hardware. The following
cleaning and polishing procedure is recommended by a brass
hardwarecompany.
1. Carefully remove hardware.
2.Gentlycleanwithextranesteelwool(No.0000)soakedinlightoil
or mild soapy water.
For tough-to-clean brass hardware:
a. Soak overnight in lacquer thinner or paint reducer.
b. Dry completely.
c. Applybrasspolishtodryhardware(followinstructionson
manufacturer’slabel).
d. After polishing, apply several coats of high quality, non-abrasive
carwax.
e.Prolongnishwithfollow-upwaxapplications.
3. Reinstall hardware.
Heavy Cleaning
Solvents, abrasives and other cleaners could cause damage to protective
coatings on hardware. If the general cleaning procedure is not
sufcient, call us for recommendations.
12/17
5