Instructions / Assembly
INSTALLATION INSTRUCTIONS
for Vinyl Patio Doors without Nailing Fin (JII015)
3
1
2
REMOVE PACKAGING
Remove shipping materials such as corner covers, shipping blocks or
pads. Remove any temporary handles just prior to installation into the
rough opening.
INSPECT PATIO DOOR
difference)
height of the patio
door are each
than the rough
opening width/
height. Mulled
smaller.
opening is square.
The (A) and (B)
measurements
should be the same.
Maximum allowable
deviation from square
efciency requirements, etc.)
If any of the above conditions represent a concern, or if you expect
for recommendations.
Verify Square, Level, & Plumb
A
B
D
E
openings.
3
PREPARE SILL PAN
material to the
length shown.
2. Lightly crease folding
two short sides and
one long side.
3. Measure the width
of the frame and add
from the back edge
and lightly crease a
folding line across
the sheet material.
5. For step-down
at the folding line
on both sides of the
sheet material.
For continuous
slab, remove ap
Measure
frame
width
Interior
Frame width
Folding line
6. For continuous slab,
cut across the folding
line.
sides up to make a
3-sided box, and, for
step-down landings,
fold the front ap
down.
Fold sides and back up
Fold corner
forward
Fold front
ap down